Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Osage orange

Posts

Osage orange

#1

Osage orange

Bert

>I cut some osage orange that was down but not dead. I rough turned a bowl and then microwaved it. Unlike cherry, oak, and apple that I have microwaved, this wood lost little or no weight even with repeated microwaving. So I finish turned it. Now I don't know whether to put a finish on it. Does anyone have some advice? What kind of finish do you recommend? Thank you for your help.

Re: Osage orange

#2

A couple finishes

Dominic Greco in Richboro, PA

>Bert,

Osage is one of my favorite woods to turn. Don't be put off by everyone saying "The bright yellow color won't last....". (funny how you don't hear something similar about cherry's color darkening) Yes, it does mellow over time to a rich golden brown. But I think it's just a pretty.

As for finishes for Osage, I prefer to wet sand to 600 grit with a 50/50 mix of Varnish/Mineral Spirits. I use McClusky's Spar varnish (in the red can). I was told that you should use a varnish that has Alkyd resins in it to help stiffen the fibers of the end grain.

This wet sanding fills the open pores of the wood and gives you an ultra smooth surface. I then let the bowl dry for a week and apply Watco's Danish Oil.

I've also used Woodcraft's Urethane Oil, and Tried And True's Original Wood Finish with success. Both work well, but I prefer to use wet sand (as I detail above) first.

Good luck,

Dominic

Re: Osage orange

#3

A sample

Dominic Greco in Richboro, PA

>

Here's a pic of an Osage Orange Platter I turned last year. I wet sanded this and then finished with Watco's Danish Oil.


img

Re: Osage orange

#4

Re: A sample

Mike Rubes, Apex, NC

>Hi Dom,

I hope things are going well in PA for you. I've been as busy as the proverbial one armed paper hanger down here! No time to turn or even read WC. Glad I stopped by for a quick peek at lunch today.

I like the shine and sheen on that piece. What did you use to burn the rings? I have problems doing that with a coil of wire. I only get good results on the outsides of bowls.

Thanks,

Mike

Like a one legged man....

Re: Osage orange

#5

Hi Mike

Dominic Greco in Richboro, PA

>Mike,

Nice to hear from you! I was wondering where you'd gotten to.

As far as burning those lines: I scribed the grooves with the point of my skew. While the platter was still held by the chuck, I bumped the RPMs up a bit, got a small piece of black veneer, and held it against the groove. Friction did the rest. If you don't have any veneer, you can also use a piece of plastic laminate. But score the groove first. It works much better if you form a "track" for your veneer/laminate to ride in.

See ya around,

Dominic