Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

chain saw has lost power

Posts

chain saw has lost power

#1

chain saw has lost power

Lan Brady

>I need help again. My chainsaw will start immediately, it will rev up quickly. But, When you put it to the wood, it has no power? The chain just bites in and stops.

Just started doing that. Any ideas what is wrong?

Thansk, Lan

Re: chain saw has lost power

#2

Re: chain saw has lost power

Kevin Turner

>Was there new fuel in it? oil/ ratio right?( winter,summer/ fall,spring bar oil? Check for proper vacuum.If all fails. Rings??? Check the compression. Chain too tight? check the filter.Choke settings?. Just off the cuff things I could think of...

Re: chain saw has lost power

#3

Re: chain saw has lost power

Jerry Whitaker

>When that happens to me...it is usually a dirty filter

Re: chain saw has lost power

#4

check rim or sprocket --

hank2

>if the rpms don't bog down, then it probably is a worn sprocket or rim

Re: chain saw has lost power

#5

Re: chain saw has lost power

Kevin Gerstenecker

>Check the spark arrestor screen, located in a removeble plate on the exhaust port of the muffler. These are usually easy to get to, at least on saws I am familiar with they are. This screen can get cloggged with carbon and cause the sympton you describe. I always remove that arrestor screen as soon as I get a new saw.

Re: chain saw has lost power

#6

Re: Carburator Trouble

Bruce in Saint John N.B. Canada

>Sounds to me like a dirty filter, probably the air filter or screen. I doubt very much if is a compression or vacuum problem as you say it starts easy so that would rule out piston rings. If the chain were too tight it would no doubt show symptoms you describe, like when the load comes on the engine it dies or boggs down. Oh must not forget the carburator, it could be dirty or your high speed mixture screw may be out of adjustment. In other words High speed air fuel ratio not correct, don't forget that engine requires (as do most gas engines) a large amount of air for combustion. Seems to me the ratio is about 8 or 9 thousand to one, in other words for every gallon of gas it burns it also burns around 9 thousand gallons of air. Good job air is not as expensive as gas, what. Hope this helps out, please let us know what you find, GOOD LUCK.

Bruce in Saint John, N.B.

Re: chain saw has lost power

#7

Re: chain saw has lost power-Thank you

Lan Brady

>To everyone that responded. I have tried everything mentioned. Teh filter was dirty, the carb-high needed adjusting. The saw is as clean now as the day I bought it. Each item has helped, but it is still not performing like it should. I think I will give in and seek professional help. (for the saw, not me!)

I very much appreciate all the help, Lan