Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

little hollow form

Posts

little hollow form

#1

little hollow form

tek-Brunswick, Ohio

>This is only 2" high. It was turned from Lilac roots. I squirted thin CA glue in the bark inclusions before turning. Some dirt and sand were in the inclusions. The CA glue turned them into sandstone. I had as much time sharpening tools as I did turning. I left the inside rougher than I would like, but didn't want to struggle with the dirt and grit any longer. My wife likes it anyway and that's what counts.

Tom


img

Re: little hollow form

#2

another view 

tek-Brunswick, Ohio

>


img

Re: little hollow form

#3

Re: little hollow form

Ed Kelle

>Nice! OK, I have not tried hollowing anything with voids so far, so how do you deal with them? Do you turn the speed up higher so you are less likely to get catches with negative space? I am guessing you are using some miniature tools on such a small size as well. This definitely has some nice character to it, great job

Re: little hollow form

#4

Re: little hollow form

tek-Brunswick, Ohio

>I'm think my speed was around 1000 rpm. I have a Nova 3000 lathe with a variable speed dc motor. I don't have an rpm readout on it. I just go with what feel like it is working. I have a set of the Kelton Mini Hollowing tools. I was removed what I could with a home made 5/16 flat scraper 1 st. The voids are not that tricky just use a light tough. There is an advantage to the voids. They make it easier to judge your wall thickness. Play around with your lighting. You can see the wall thickness and the end of your tool through the void as you turn when you get it right.