drill rod M2
Lan Brady
>I just bought several pieces of hss m2 drill rod- 1/16",1/8" and 1/4" pieces. How do I cut this too length? Can it be done with a hacksaw or will i need heavy tools?
Thanks, Lan
Knowledge You Can Build On — Est. 1998
drill rod M2
Lan Brady
>I just bought several pieces of hss m2 drill rod- 1/16",1/8" and 1/4" pieces. How do I cut this too length? Can it be done with a hacksaw or will i need heavy tools?
Thanks, Lan
Re: drill rod M2
John K Jordan
>I would reach first for an abrasive cutoff wheel.
JKJ in East TN
Re: drill rod M2
John Lucas
>Lan It will cut quite easily with a hacksaw. It comes non-hardened.
Re: drill rod M2
Lan Brady
>Both John's,
Thanks for the help. It never occured to me that it would not already be hardened.
Lan
Re: drill rod M2
tek-Brunswick, Ohio
>Was it drill rod or dril blanks? My understanding is rod is unhardend and blanks are hardend. I only have experience with 01 drill rod. Do I have that right?
Re: drill rod M2
jwoodwright
>If it's hardened... EYE Protection ON... Use Vise-Grips to hold Rod, use corner of Bench Grinder Wheel to Score Rod all the way around. Lock down section in Vise. Wrap a rag around section, not in Vise. Use a Ball Peen Hammer to Snap-Off Section. Once again, using Vise-Grips, dress each cut section on the Wheel...
Re: drill rod M2
Lan Brady
>Thanks to everyone for the help. I cannot wait to get back in the shop and find out just what I do have. I now have enough knowledge to use it, hardened or not.
I am so glad that I use this sight!, Lan