Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Buffing wheel arbor got hot. Is this normal?

Posts

Buffing wheel arbor got hot. Is this normal?

#1

Buffing wheel arbor got hot. Is this normal?

Al Crandall--NE of Indy--

>The arbor for the tripoli 8" buffing wheel got so hot that it would have burned my hand if I had held it on the head of the arbor. The 3/8" washer which was between the arbor nut and my spindle adapter was hot also when I removed it to install it on the next wheel. Has anyone else noticed this? How could this happen?

Re: Buffing wheel arbor got hot. Is this normal?

#2

Re: Buffing wheel arbor got hot. Is this normal?

Gary in Zirconia, NC

>The buffing wheel must be spinning (slipping) on the arbor shaft as it is turning, thus causing friction and heat.

Re: Buffing wheel arbor got hot. Is this normal?

#3

Re: Buffing wheel arbor got hot. Is this normal?

Brian Hahn in SW Wisconsin

>Warm is normal, HOT is not. Make sure the arbor bearings are properly lubricated. Many arbors (and motors) have a port for oiling the bearing. Drip a little oil into that.

Unbalanced loads can also heat up bearings. So you might also check that your buff isn't badly out of balance.

On the other hand, the motor I use for buffing gets pretty toasty after a long session, but I'm running it at almost full load and it's still within it's design limits.

Re: Buffing wheel arbor got hot. Is this normal?

#4

Re: Never thought of that. Thanks, I'll check it.

Al Crandall--NE of Indy--

>

Re: Buffing wheel arbor got hot. Is this normal?

#5

Re: The buff is a lathe accessory, so no bearings.

Al Crandall--NE of Indy--

>Thanks for your thoughts, but the wheels each came with just a simple 3/8-16 threaded arbor with a large diameter head which is poked through them and nutted on the back side. They screw into a long connector nut which I epoxied into a dedicated faceplate adapter. The head of the arbor appears to be running very true. There are no bearings involved to heat up, so the hotness caught me off guard and threw me for a loop.

Re: Buffing wheel arbor got hot. Is this normal?

#6

I suppose...

Rod Peterson -- Ormond Beach

>...you're expecting some remark out of me, what with that groundball you lobbed in there. Well, I think I owe you a pass, particularly because of the cheap shot I took I took at you on the zinc welding thread.

But, just so you know I know...

Rod

Re: Buffing wheel arbor got hot. Is this normal?

#7

Re: For those keeping score: Rod,5...Al,1

Al Crandall--NE of Indy--

>I thought about you before posting that other one. This one I was totally oblivious and got blindsided. Dang you're good.