Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Help making a profiling tool

Posts

Help making a profiling tool

#1

Help making a profiling tool

Ralph T

>I'll be making a profiling tool for turned spindles and looking for tips, recommendations or sources for ideas on the topic. Conventionally they might be used for fluting or reeding, but probably have more possibilities that I'd like to explore. I've looked around and there just isn't much information out there on the topic.

I'd like the tool to follow the diameter of the turning as opposed to just following the straight lathe axis. The most helpful source I've found so far has been an article about turning bed posts from an '85 Fine Woodworking. There are several photos of a shop-made tool in use to flute a bedpost. It seems like a versatile tool and could allow for some other creative possibilities. It's made so that a pivoting arm holds a router horizontal and perpindicular to the lathe axis. I assume a bearing on the bit follows the work profile as the whole sled rides along the ways of the lathe (a picture would be worth a thousand words here).

Anyone have and ideas on the topic or recommendations for links or resources?

-Ralph

Re: Help making a profiling tool

#2

Re: Help making a profiling tool

John Lucas

>Ralph There are a few article here and there but they are hard to find. I've done it two ways. One was to make a box that fit on the lathe. The router rides on this box and I would make a profile that the router base rode on and the profile matched the turning. I had to make 2 matching profiles which is actually pretty easy. It also assumes that your router base is wider than the turning.

The other way was to make a table that sits where your tool rest sits. Then I set the router or flex shaft tool on the flat area and made a profile that this followed. It had the advantage of being able to use my dremel, or the flex shaft tool, air tool,or router. The disadvantage was having to build a carriage for each tool. Another advantage is that you can do this on any size turning.

The advantages of these methods, over having a bearing that follows the turnings, is you can make the flute change thickness or come out of the cut with a taper or even cut through an existing feature such as a raised bead. It gives you a lot more control over the final cut.

Re: Help making a profiling tool

#3

Lathe table for the router

Fred in NC

>I ran into the same problem. Besides, adjusting the height of the table so the router bit hits where I want to was very tricky.

My solution was to make what I call a "low banjo" so I can have a table with adjustable height. This is because the normal banjos are too high to have a table with a router riding on it. Since the post is made from threaded rod it can be easily adjusted with two nuts. For a longer table I just use two of these banjos. The plate at the top of the rod has holes to attach the wood table.

This table works well with routers, Dremel type tools, flex shafts, and a high speed spindle that I had made.

At the left of the pic is the indexing wheel setup.

(Remove HEHE for email)


img

Re: Help making a profiling tool

#4

A table in place 

Fred in NC

>


img