Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Back hollowing boxes help

Posts

Back hollowing boxes help

#1

Back hollowing boxes help

phil in NJ

>Hi,

I'm learning to back-hollow boxes (as in Raffan's videos). I seem to be able to do OK, but I get quite a small catches inside, and I seem to have to work far harder than Raffan does on his videos to do the job.

I'm using a 1/2" shallow flute gouge on approx 3" mahogany (KD) box blanks.

The grind on the gouge is the standard one on the Sorby gouge right now, which is perhaps too steep, perhaps I should elongate the grind?

Thanks!

-Phil

Re: Back hollowing boxes help

#2

Re: Back hollowing boxes help

John K Jordan

>>I seem to have to work far harder than Raffan

>does on his videos to do the job...

Sorry, I can't help but I had to laugh when I read that! I have to work far harder than Raffan on EVERY thing he does on his videos. And it takes me at least four times as long.

JKJ in East TN

Re: Back hollowing boxes help

#3

Re: Back hollowing boxes help

phil in NJ

>Agreed. :)

By that statement I didn't mean "other things I can do as well as Raffan does!"

Re: Back hollowing boxes help

#4

Re: Back hollowing boxes help

Barry Turner

>Didn't you know? That back-hollowing thing only works down under. (It probably wouldn't work for me even there!)

Re: Back hollowing boxes help

#5

Re: Back hollowing boxes help

Ken Grunke from SW WI

>When I was doing this a lot, I used a 1/2" spindle gouge with a standard ladyfinger grind and it worked great. The grind had a only a minimal amount of sweep-back on the side wings, and was about a 45 degree bevel.

But when I reground the gouge to the Irish, or Ellsworth, grind, it became more difficult and catchy.

The trick is to just keep the bevel rubbing as you come up from center and along the side (towards the top).

These days, I use a hook tool, Berger tool, or a skewchigouge to hollow after drilling a starting hole.