Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Help finding thread adapter for older Rockwell

Posts

Help finding thread adapter for older Rockwell

#1

Help finding thread adapter for older Rockwell

Wayne Leach

>Hi Everyone,

I have an older Rockwell lathe which has uncommon thread on headstock shaft 7/8Dia. x 14TPI I would like to get an adapter to convert to 1"dia. x 8 TPI so that I may purchase chucks etc. Any ideas where to purchase (I have looked at the usual places like Craft Supplies, Rockler etc. with no luck)! Will I have to get it specialy made???

Any ideas or suggestions would be appreciated.

Wayne in Northwestern Ontario

Re: Help finding thread adapter for older Rockwell

#2

Oneway...

Peter Teubel

>They can make any adapter you want. Not cheap, but top quality.

Re: Help finding thread adapter for older Rockwell

#3

Re: Help finding thread adapter for older Rockwell

Steve Mushinski

>Another might be to look up a machineshop in your area and ask them to make on for you. It would take a very little time or material to do one. Just make sure they put in two flats on each side to be able to put a wrench on it to take it off.

The Oneway ones are every good and I believe the are case hardend therefore the higher price.

Steve

Re: Help finding thread adapter for older Rockwell

#4

Re: Help finding thread adapter for older Rockwell

John Lucas

>Wayne Grizzley has a lot of odd size chucks inserts and faceplates. Try there. If not I think the folks at www.bestwoodtools.com will make you one at a reasonable price. They are very high quality.

Re: Help finding thread adapter for older Rockwell

#5

Re: Help finding thread adapter for older Rockwell

Wayne Leach

>John,

Thanks for the info. I went to the site and made enquiries and yes they will make the adapter!

Thanks to all who replied, apprecate the help.

Regards, Wayne

Re: Help finding thread adapter for older Rockwell

#6

Re: Help finding thread adapter for older Rockwell *LINK*

Walter Ahlgrim

>Teknatool has a insert for there Super Nova II that may fit your lathe part # IVNS 7/8 14 TPI NF RH. I did not look but I would bet that others chuck have the correct insert. With chuck, insert and a few face plates you should be in good shape.


FITTING A NOVA OR SUPERNOVA CHUCK TO YOUR LATHE,

Re: Help finding thread adapter for older Rockwell

#7

Re: Help finding thread adapter for older Rockwell

Wayne Leach

>Walter,

Thanks a bunch for your helpful info. I will check it out!

REgards,

Wayne