Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Danger in Wetsanding?

Posts

Danger in Wetsanding?

#1

Danger in Wetsanding?

George Van in WI

>While wetsanding with 3M WetorDry 400 grit I notice the finish I am using darkening. I am wetsanding cherry at this time. If this were maple would I be staining the maple black? I would rather learn on others experience than wreck a maple bowl to find out. I assume wet sanding using the finish is a common procedure? I am not letting the finish get gummy or putting excessive pressure against the bowl. I am sanding off the lathe.

Re: Danger in Wetsanding?

#2

Re: Danger in Wetsanding?

Mike Schwing from Md.

>George, if you are wetsanding with black paper - as the paper and grit deteriorate, guess where they're going? That is another reason I do not wetsand bare wood, but lots of folks have good results doing so.

Re: Danger in Wetsanding?

#3

Re: Danger in Wetsanding?

George Van in WI

>Mike, I started wet sanding after sealing with Deft followed by a coat of oil/varnish and drying 24 hours. At this stage of finishing do you still dry sand before recoating? I could knock down the finish with Liberon 0000 steel wool and recoat but I was hoping to fill the grain with the slurry while wet sanding. Do you ever use black wetordry?

Re: Danger in Wetsanding?

#4

Re: Danger in Wetsanding?

Wally Dickerman in Arizona

>George, I oil sand with the heaviest grit or two. I find that it's very effective in reducing sanding time. I use finishing oil. I don't use oil with the finer grits, although some folks do. Don't over-use the paper. Don't sand sharp corners with black SP. You'll transfer the color to the wood.

Wally

Re: Danger in Wetsanding?

#5

Re: Danger in Wetsanding?

George Van in WI

>Wally, when you sand with the heavier grits are you using wet/dry black or another type like industrial abrasives or 3M sheets? I will watch the corners, as this may be one of the problem areas I am encountering. I also notice the problem more on the inside where the paper is flexed more at the bottom and up near the recessed rim.

Re: Danger in Wetsanding?

#6

Re: Danger in Wetsanding?

Wally Dickerman in Arizona

>I use Norton Adalox, an alum. oxide paper. I use wet/dry in 400, 600, 1500...without oil.

Keep the paper moving and avoid heat. Again, don't over-use it.

Wally

Re: Danger in Wetsanding?

#7

Re: Danger in Wetsanding?

John Lucas

>George I use Murphy Oil soap to wetsand wood that already has a finish. I try to wipe it off frequently so there isn't as much build up of the slurry.

When I do furniture I usually use an oil finish and will put on several layers before i start wet sanding. Then I will wet sand with 600 grit using what ever oil finish I'm applying.

Re: Danger in Wetsanding?

#8

Re: Danger in Wetsanding?

George Van in WI

>Wally, I will look at the Adalox.

John, I will get some Murphy Oil and give it a try.

Thanks for the tips!