Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

photo booth done, now i need to practice *LINK*

Posts

photo booth done, now i need to practice *LINK*

#1

photo booth done, now i need to practice *LINK*

Sascha

>ran around today to get all the parts for a photo booth, 3/4 PVC, non rip nylon, gray backdrop/seemless paper and a few lights.

the whole thing is a bit bigger than i thought i wanted it, but then i thought it might come in handy, its about 36"x36"x55", i set it up on an old workbench i had and some ply. the fabric is attached with PVC clamps i made from 1" pvc pipe that i ripped in just about half so it would snap over the 3/4" pipe of the frame.

then i set up the lights and played around with it, i still need to figure the best way of lighting it. i also hooked up a TV to the camera so i don't have to look so much on that little screen of the camera.

here a shot of the setup and a few pics i took. now i just need to find the best way of lighting the pieces and i am ready for better pics.

the camera setting was on low quality so i wouldn't have to get each pic web ready, but for a portfolio i would shoot in high resolution.

thanx guys for past posts about this, i have been wanting to do this for a while.

sascha


img

some pics of the booth and some results

Re: photo booth done, now i need to practice *LINK*

#2

photo booth is never done! *LINK*

Mike Schwing from Md.

>But it gets closer and closer with every photo session.

Your basic booth looks just like many of ours. You'll find out on your own, but I hope you don't mind a little advance info - your choice in lighting placement will not give you the best results.

When possible, illumate through the white material, as you have with the 2 halogens on the right. I would suggest lowering the lighting on those two to about middle of the booth, and then pointing one up towards the ceiling of your booth and the other down towards the table. That will help bounce light off of the top as well as illuminate the underside of your subject. Also, light from the rear does little good, so move it up towards the front.

A microphone stand/boom is a good choice to hang a light over the top of the booth and if it is bright enough you'll illuminate the top of your subject quite nicely. I have a velcro hatch in mine because sometimes I like to illuminate the interior of a vessel as in the photos linked below. ( http://mysite.verizon.net/vzeo6om6/photos/photo3.jpg and http://mysite.verizon.net/vzeo6om6/photos/photo52.jpg )

You may eventually wish to create a little front curtain to shield unwanted light or to create a diffuser for lights placed in front of the subject. Alternately, to provide light to the front/bottom, shine a light from back to front and use a bounce card to get the light to the underside of the subject.

Try to avoid shining lights directly on the subject, as it creates hotspots that viewers (and photographers) generally find undesirable. In the photo booth pic you've provided, one can easily spot the locations of your light sources. Sometimes hotspots are desired, it makes it easier to show off a really glossy piece, but not generally.

Keep it up and you'll be shooting photos like these in no time flat. They came from an almost identical setup to the one you've put together.

http://mysite.verizon.net/vzeo6om6/photos/photo1.jpg

http://mysite.verizon.net/vzeo6om6/photos/photo17.jpg


SchwingWoodWorks

Re: photo booth done, now i need to practice *LINK*

#3

Re: photo booth done, now i need to practice

John Lucas

>Looks good. I agree with Mike. Even though I use a direct light some in my work I don't recommend it for most people. I usually start with a light, or in your case 2 lights about 45 degrees up so it shines on the top and side and then as far forward as I can get it without casting a shadow of the panel on the background. This lights one side and the front fairly well. Then you can use reflectors to fill in most of the hightlights. You may have to move the main light, which is your double light, up or down or forward or back to bet a better light.

Don't try to get the light super even. Most peices look much better with one side darker than the other. this gives it shape. If you really have trouble bouncing light back into the bowl add a second light outside the panels. It should not be as bright as your main light. Move this light around until you get enough "fill" light to make the piece look nice.

Most people overlight a piece. By that I mean they try to add too many lights and make the piece flat looking with too many reflections. Ideally you want' one reflection and one shadow. If you don't have any shadows the piece looks flat. More than one reflection gets confusing but sometimes you simply must have more due to the high quality of finish most woodworkers use. Try to make any addtional reflections smaller and darker than the main reflection.

Re: photo booth done, now i need to practice *LINK*

#4

Re: photo booth done, now i need to practice

Mike Swain

>Sascha,

What's the bike wheel for, I hope it's not for powering the lights.

It'll take a lot of pedal power to keep all those lights shining brightly.

Regards....Mike Swain RPT

Re: photo booth done, now i need to practice *LINK*

#5

Re: photo booth done, now i need to practice

Sascha

>thank you so much mike and john, that is exactly what i was looking for. i will try to set up the lighting the way you suggest and play with it. i just needed a good starting point, not just knowing the on switch,haha.

awesome, i am so happy,.

thank you again

sascha

Re: photo booth done, now i need to practice *LINK*

#6

Re: photo booth done, now i need to practice

JamieDonaldson

>Too many light sources give too many highlights on the work, especially objectionable with shiny surfaces. Best set-up with least effort is to get down to a main light on the R side and bounce the fill from a white card on the L side to open up the shadows.

Re: photo booth done, now i need to practice *LINK*

#7

I agree 100 %

John Lucas

>

Re: photo booth done, now i need to practice *LINK*

#8

Re: photo booth done, now i need to practice

Ken Grunke from SW WI

>Another suggestion in addition to the other great ones:

Your backdrop doesn't need to be so high, lower it and bring it back more so A.) it's out of focus and gives the appearance of infinity;

B.) it's not directly illuminated, or not at all illuminated--the result is a nice gradiated backdrop, darkest at the top and lightest in the foreground.

You can buy gradiated backdrops, which I think is a crock of sh*t since it can be done with light only on a black or dark colored backdrop.