Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Cedar vase

Posts

Cedar vase

#1

Cedar vase

Ed Kelle

>10"H x 7" rim diameter. Done this weekend, I really did not expect to see purple in this log, the heartwood was orange on the end. For me, it was a big blank, about 14x 11 to start with, boy I wish my lathe would go slower than 500rpm cause it sure seemed fast to me. I kept it between centers for all of the outside work and even some of the initial 2" or so of hollowing. Lots of hand sanding later, I packed it in for the night and put it in a bag of shavings till Saturday. And for some odd reason it didn't warp or start to crack.

I drilled a depth hole with a nice big 1" bit and slowly worked my way down using my big ellsworth bowl gouge and a heavy duty bowl scraper. Once again, had no luck with my Sorby hollowmaster. It just loves to turn over on me even with the flat grind underneath. I went as deep as I could go, dur to the limits of my tools and toolrest, so it is about 1.5" thick at the bottom and still shows the drill hole a bit. Sanded the inside and saturated it with oil before it could start to dry out, there were already a few pith cracks forming due to the heat of sanding the inside bottom. Still in the oiling process and it is holding shape very well.

Of course after the hollowing I saw a lot of great colorings going on inside and thought, if I just went a little narrower on the outside I could have brought more color up higher on the vase. Oh well. Its a nice piece either way and probably my biggest work to date.

In the future, I should build a steady rest so I don't have to worry about launching the piece the entire time. I'd also like get a decent hollowing tool as well. I was really suprised how well the bowl gouge worked in hollowing end grain.

Learned a bunch on this piece and I am pleased with the results.


img

Re: Cedar vase

#2

Inside colorings

Ed Kelle

>Really wild stuff going on inside


img

Re: Cedar vase

#3

Re: Inside colorings

Jorge Castaneda

>Good job Ed, nice vase.

Can you tell us what kind of cedar is that?

It does not look like any cedar I know, 2 from the east coast and 4 from the west.

Thanks

Jorge

Re: Cedar vase

#4

Beautiful vase, Ed....

Frank Mutchler in Colorado Springs

>do you use a Powermatic 90? I thought you might because of your comment regarding the 500rpm low speed.

Re: Cedar vase

#5

JL

Re: Cedar vase

JL

>Quite nice and very colorful. What finish did you use?

Re: Cedar vase

#6

Re: Inside colorings

Ed Kelle

>Jorge,

I wish I knew what kind of cedar it was. It was given to me by a friend, so it was grown locally here on Long Island NY. I don't know why it became purple, when I began it, the heartwood appeared orange on the end, as I turned it I saw it was purple.

Ed

Re: Cedar vase

#7

Re: Beautiful vase, Ed....

Ed Kelle

>Thanks Frank. I have a Delta 1440. With all its problems, I wish I had a Powermatic instead.

Re: Cedar vase

#8

Re: Cedar vase

Ed Kelle

>Thanks JL. I am using Liberon finishing oil, wiped on after turning. It really soaks up the oil and I have since learned that oil is probably not the best to use on cedar. Seems like I will be oiling this for a long time. I would have soaked it, but as the vase is bigger than the bottle of finish I have... oh well

Re: Cedar vase

#9

Thanks Ed

Jorge Castaneda

>LI, NY uh?

who knows, probably it is a rare case where an atlantic red cedar grew that big in diameter; nice!