Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Help w/McNaughton and Powermatic 3520

Posts

Help w/McNaughton and Powermatic 3520

#1

Help w/McNaughton and Powermatic 3520

Frank Martin

>Just got my new McNaughton system and was all set to do my first core when I realized that the standard tool post is too short (by about an inch)for my Powermatic 3520. Looked at Kelton site and the catalog suppliers and no mention of alternate tool posts although they must exist. Anyone running this combination who can point me in the right direction for a solution??

thanks, frank

Re: Help w/McNaughton and Powermatic 3520

#2

Re: Help w/McNaughton and Powermatic 3520

Bob G.

>I saw somewhere that there were different sized posts, diameter I think. Mine was fine right out of the box for the 3520a.

You may search through some of the older messages and e-mail the U.S. rep for Kelton maybe he can help.

Bob

Re: Help w/McNaughton and Powermatic 3520

#3

Re: Help w/McNaughton and Powermatic 3520

Greg Jensen

>You need a 1" long post that has the 1" section that is 4" long. The standard post is 2 3/4" long. Your supplier should have a replacment at no cost. I normally have some but am currently out or I would send you one.

The Powermatic Banjo is shorter than most.

Greg Jensen

North American Rep for Kelton Tools

Re: Help w/McNaughton and Powermatic 3520

#4

Nice stealth gloat Frank!

Gerry in Maryland

>