Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Oneway bowl steady questions

Posts

Oneway bowl steady questions

#1

Oneway bowl steady questions

Mike Schwing from Md.

>Hi guys/gals.

I received the Oneway bowl steady in the mail yesterday. I have a couple of questions about the proper use of it if you don't mind.

1. How much tension does one apply? I was surprised to see how much you could move the bowl just by squeezing the clamps a bit. I'm guessing the wheels should "just touch" but don't know.

2. How high should the assembly sit? I'd imagine the crossbar should be level with the spindle, but no reference is made to that in the manual.

I'm looking forward to using this with my larger bowls!

Thanks.

Re: Oneway bowl steady questions

#2

Re: Oneway bowl steady questions

Mark Kauder, Phenix City, AL

>Hey Mike,

As you know, I use the Oneway Bowl Steady. For most of my turning, I use two of them stacked on top of each other with the wheels on either side.

1) Just a touch is right. Too much pressure can force the bowl off axis, and create an out-of-round situation.

2) You need to be near spindle height with the center of the assembly, but don't have to be exact.

The last thing - again not in the instructions: Make sure that the wheels are perpendicular to the bowl surface, to to the bed of the lathe. If they are off of 90 degrees to the surfase of the bowl, it will cause a scuffing action that can wear the wheels at a tremendous rate. DAMHIKT.

Mark

Re: Oneway bowl steady questions

#3

Re: Oneway bowl steady questions

JamieDonaldson

>I have infrequently used my Oneway spindle steady(2 wheels) while hollowing- place the wheels in the area being cut, and just enough pressure to keep the wheels in good contact with the wood. A good tip is to wrap the area under the wheels tightly with masking tape to reduce wheel marks since I usually sand the exterior before hollowing.

Re: Oneway bowl steady questions

#4

Re: Oneway bowl steady questions

Mark Kauder, Phenix City, AL

>Good Point I forgot, Jamie. I use the blue painters tape.

Mark

Re: Oneway bowl steady questions

#5

Re: Oneway bowl steady questions

bill dotten

>big advantage not only with regular bowls but excellent with Kelton bowl saver and deep hollowing rig

Dusty

Re: Oneway bowl steady questions

#6

Thanks everybody

Mike Schwing from Md.

>Yup Mark - our little talk about it in KC clinched the deal for me. Had 2 $20 gift certificates from Packard to put towards it, so I went online and ordered the thing, totally forgetting about the gift certificates!

Used it last evening, will take a bit of getting used to but I experienced absolutely no rim flex on a 14" bowl - what a treat!

Thanks again guys.

Re: Oneway bowl steady questions

#7

Don't understand

Bill Howatt

>It seems to me there would be more scuffing if the wheels were perpendicular to the bowl surface and less if perpendicular to the bed.

Comments?

Bill