Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Poly over Tung Oil Finish

Posts

Poly over Tung Oil Finish

#1

Poly over Tung Oil Finish

TomW in SouthJersey

>OK, first I'll admit it is Formby's high gloss tung oil which I've read here isn't really tung oil. But I have 3 coats on a black walnut bowl and would like to put a durable finish on it. I was considering a wipe on poly. Any advice? I don't have spray equipment but do have a compressor and could buy a HVLP gun (I've already spent way more on this addiction than I ever thought going in to it whats a few more $$$).

I also have accumulated a fairly large variety of waxes and have Mylands friction polish and some carnuba wax sticks.

I'd appreciate all good advice and warnings before I mess this one up.

Tom Wright

Re: Poly over Tung Oil Finish

#2

Re: Poly over Tung Oil Finish

Russ Fairfield

>There is no problem with using the Wipe-On Poly over the Formby's Oil finish or any other oil finish, PROVIDED THAT.... you sand back the surface of the oil finish to no finer than 220 grit. The bond between the finishes will be strictly mechanical, and you have to give the Poly something to grip onto. Then preceed with the multiple wipe-on coats until you get the desired gloss.

Re: Poly over Tung Oil Finish

#3

Re: Poly over Tung Oil Finish

TomW in SouthJersey

>Russ

Thanks. It has been drying 2 weeks so far in humid NewJersey summer heat. It feels dry to the touch. Is this sufficient drying time?

Tom

Re: Poly over Tung Oil Finish

#4

Keith Tompkins

Re: Poly over Tung Oil Finish

Keith Tompkins

>Hi Tom, if it sands and leaves a white powdery residue, it should be fine.