Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

scraper angle

Posts

scraper angle

#1

scraper angle

DWFII

>I just purchased a Henry Taylor square scraper. I know that I will want to cut the leading edge back a bit on the right hand side but I have two questions that go beyond that...

First, this scraper has a grind angle of about 75*. Yet I see more experienced turners sometimes suggesting 55*. This seems to me like it might turn my scarper into a bedan. Any thoughts on scraper angle?

Also, while cutting back the leading edge IU thought I might sharpen the left side a bit. I would appreciate any thought on this as well...should I do it? How do I go about it? What angle for the side and how far back?

DW

In the High Desert of Central Oregon

Re: scraper angle

#2

Re: scraper angle

Russell L. Babbitt Jr.

>Go ahead and grind the side. Scraper angles are not critical.

Re: scraper angle

#3

Re: scraper angle

Wally Dickerman

>Hi DW...I grind my scrapers at 60 deg. Gives a better edge, but probably won't last quite as long as a lesser angle. Scraper edges should be touched up frequently anyway to maintain a burr.

I side-grind a square nose tool on both sides for about an inch. 10 or 15 deg. works well. This is a very usefull tool, used in a number of ways.

We just returned to Portland after a visiting family and friends in the Puget Sound area. We'll be heading back to Arizona next week.

Wally

Re: scraper angle

#4

Re: scraper angle

Bill Grumbine (Kutztown PA)

>Hi DW

I grind mine to a 30 deg angle, but that is probably the same thing as Wally's 60 deg angle measured from a different plane. I have been telling people for years that this angle works best (And it does not have to be exact), but it was recently brought to my attention that I should specify from where the 30 deg is measured. So, I measure from the vertical plane, and not the top surface of the scraper, and that is what I mean by 30 degrees.

Bill

Re: scraper angle

#5

Re: scraper angle

DWFII

>Thanks Wally and Russell...I appreciate the advice.

DW

In the High Desert of Central Oregon

Re: scraper angle

#6

actually 2 tools in one

tdaniel

>DW, a tool as you describe can be a shearing tool or a scraper or both. If you hold the handle high it is a scraper; if you ride the bevel it is a shearing tool. With the handle high you need the burr but with the handle low you might want to hone the burr off.

TD

Re: scraper angle

#7

Hey Wally did I miss you and Jane.

Dave Smith, Longview, WA

>Guess we missed you this summer. I assume you will not be going to Sophie's BBQ next weekend. Too bad as I will not be visiting AZ this winter. I will miss the great meals at Jane's Restaurant. No better food anywhere in the world.

I may have some some wood you may be interested in turning. Drop me a line if you are interested.

Dave Smith

Nursing a sore back in Longview, WA.