Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Nova DVR head locking problem.

Posts

Nova DVR head locking problem.

#1

Nova DVR head locking problem.

Colin Spencer

>I have my DVR set up but have a problem. The headstock won't lock. It rocks backwards and forwards about 2mm (I can pick the head up about 2mm from the bed), the rotation locks fine and is perfectly aligned with the tailsock. Is there some sort of adjustment to the large cone bolt that is supposed to lock it? I have tightened it up as far as I dare and it has bottomed out in the hole but the machined line is still about 1mm from the bed casting.

I have emailed Teknatool but of course due to the time difference I won't get a reply until after the weekend and I would like to use it this weekend.

TIA

Colin

Re: Nova DVR head locking problem.

#2

Re: Nova DVR head locking problem.

Ralph Tursini

>Our club had a similar issue with our Nova (step pulley model). It was the large central pin that the headstock swivels on. It isn't fixed to either the headstock or bed assembly and so it freely rotates. This pin has a tapered hole in its side which needs to be aligned towards the outboard end of the lathe to accept the tip of the threaded cone bolt.

I realigned the pin by holding it while rotating the headstock. Shine a light into the cone bolt hole to see when its aligned.

I think the problem was caused by backing out the cone bolt too far and rotating the headstock.

Hope this helps

-Ralph