Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Nylon Spindle washers are bad, M-kay?

Posts

Nylon Spindle washers are bad, M-kay?

#1

Nylon Spindle washers are bad, M-kay?

Devon Palmer

>Heyas all,

Just got back from my first symposium and learned TONS (I really wish I had taken better notes) One the the biggest and simplest things I garnered was the impact of the nylon washer I had been using behind my chuck. John Jordan stated that these things disrupt the mating surface and provided a point for flex.

Sure enough, when I removed mine, it eliminated the low frequency vibration I'd be experiencing when roughing on a screw, and hollowing. It feels more "solid" now. To avoid "stuck Chucks", gently tighten the chuck on the spindle and avoid "snapping" it into place.

I didn't throw the washer away, but, not sure what I'll do with it now (maybe inlay it in the bottom of a bowl or something LOL)

Re: Nylon Spindle washers are bad, M-kay?

#2

Thickness?

Bill Howatt

>Interesting and in the "sort-of-makes-sense" category. I use a washer made from a thin margarine container lid and haven't noticed any problem for what I am doing. How thick was your nylon washer?

Thanks,

Bill

Re: Nylon Spindle washers are bad, M-kay?

#3

Re: Nylon Spindle washers

Mark Mandell - Gone Round In Jersey

>Devon,

Use it as a "seal" for mounting your vacuum chuck. [Assuming you use vacuum of course]

M

Re: Nylon Spindle washers are bad, M-kay?

#4

Re: Thickness?

Norm Smith in Nova Scotia

>Bill, I also use a washer made from a margarine container and havent noticed anything different.

Norm

Re: Nylon Spindle washers are bad, M-kay?

#5

Re: Thickness?

Fred in NC

>To me the washer is insurance that I will not have a major stuck chuck problem. It needs to be very thin, so it does not have a lot of "give."

The lids mentioned above are good for that.

Re: Nylon Spindle washers are bad, M-kay?

#6

Re: Nylon Spindle washers are bad, M-kay?

Ron in Drums PA

>I use thin corragated cardboard. It seems to crush evenly.

Re: Nylon Spindle washers are bad, M-kay?

#7

Try Mylar washers

Brian Hahn in SW Wisconsin

>I use a washer cut from an old Mylar vellum sheet -- the stuff that engineering drawings were made on before everyone switched to CAD. It's about 0.010" thick, very stiff and strong. I always spin my chucks and faceplates on to eliminate any potential vibration. I usually need to use a wrench to get the chuck off, but haven't had one frozen on with this method. I've also never had a vibration problem with the chuck or faceplate.

I've also heard of people using brass shim stock. It too is stiff enough not to contribute to vibration problems.

Re: Nylon Spindle washers are bad, M-kay?

#8

Re: Try Mylar washers

John Lucas

>With the new Powermatic 2035 I have to use 2 washers on some of my faceplates and chucks because the spindle is that much longer. On the chucks and faceplates that fit I put a very small amount of air tool oil on the face of the spindle. Since I started doing this I haven't had a chuck lock up.