Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Metal Rethreading Question

Posts

Metal Rethreading Question

#1

Metal Rethreading Question

Clem Wixted

>I would like to know if a 1-1/4" x 8 TPI (female) to 33mm x 3.5mm (male) spindle adapter can be rethreaded on the 33mm male threads to 1 X 8 inch?

Is there enough metal on the 33mm threaded male end to allow it to be reduced and threaded to 1 inch by 8 threads to use on my wood lathe?

Thanks,

Clem

Re: Metal Rethreading Question

#2

Re: Metal Rethreading Question

Fred in NC

>Clem, to determine if there is enough metal for rethreading, use a caliper and measure the inside diameter of the threaded part. It needs to be 1" or so.

I do some work with metal. I am not sure if I would attempt rethreading the adaptor. You need a machinist with a good metal lathe, and that can be expensive, unless you have a machinist friend.

Besides, I am not sure you can get a perfect threading job. The concentricity has to be between the internal and external threads. Just chucking the adpator by the unthreaded part will not guarantee that. You might end up with a very wobbly setup.

In your case, I would buy a new adaptor, and try to sell the old one.

Re: Metal Rethreading Question

#3

Good Points

Clem Wixted

>Fred,

I thought of e-mailing you directly because I knew that you would have some good input, but I couldn't find your e-mail address.

Thanks for the information. Back to the drawing board :-)

Clem