New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Bandsaw motormania

Posts

Bandsaw motormania

#1

Dave Shombert

Bandsaw motormania

Dave Shombert

>Restoration continues on this Powermatic model 143 wood/metal cutting BS I got at an auction recently. It's got a 3 phase motor, looks like a pretty good one - Leeson, 3/4 HP, TEFC, looks almost new. I'm starting to think this machine isn't all that old. Anyway, I was planning on replacing that with a single phase motor until a friend told about static phase inverters - makes the three phase motor run on single phase. There's a company that sells them on eBay, about $90 which is a good bit less than a new motor.

Anybody have any experience with these things? From the ad on eBay, I gather there's a fair amount of power loss in the device but I'm not sure. My friend claims the advantage is that the 3-phase motor will run more smoothly.

Any advice appreciated. Thanks in advance,

Dave Shombert

Elkins, WV

Re: Bandsaw motormania

#2

Re: Bandsaw motormania *LINK*

Colin Spencer

>If you have a look at the link below you will see the upgrade I did to my lathe using one of these invertors. If you want any more information please let me know.


Lathe Upgrade

Re: Bandsaw motormania

#3

Re: Bandsaw motormania *LINK*

john lucas

>Dave

What you need to look at is Variable Frequency Drives. They don't rob you of horsepower the way a static drive does. Plus they give you varible speed. There are also quite a few sites one the web that will tell you how to create 3 phase using an old motor. That also eats up horsepower but is a really inexpensive way to go.


http://www.dealerselectric.com

Re: Bandsaw motormania

#4

Dave Shombert

Re: Bandsaw motormania

Dave Shombert

>Thanks for the suggestions, guys. I found a new 1 HP Baldor motor on eBay for $150 including shipping, so I'm going with that. It's not much more than the static converter would have been, and that setup (with the existing 3-ph. motor) would have me limited to something less than 3/4 HP.

I'm aware of the variable speed drives but, as it happens, this bandsaw IS variable speed - four pulley positions and a two-speed gearbox. Man, this thing is built like a tank. I don't know how old it is - I suspect it's newer than its appearance suggested at first - but you sure don't see them built like this anymore. Should be up and running by the end of next week.

Thanks again,

Dave