New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

The chestnut bowl is in the tank.

Posts

The chestnut bowl is in the tank.

#1

The chestnut bowl is in the tank.

Craig Daymon

>I finished turning the American Chestnut bowl. I did some reading on the American Chestnut and as the blight of the tree in the U.S. was key to the downfall of the leather tanning industry in the U.S., I thought fuming the bowl was an appropriate finish technique for the project as both relate to its high tannin content.

The bowl is sitting in a styrofoam container along with 2 small cups of household ammonia. It will be in there for about 14 hours before coming out to air for about another 12 hours and getting the first coat of finish. It is upside-down on top of some packing foam and weighted down. The weight is sitting on top of a piece of MDF wit 4 toothpicks in it to minimize surfacce contact. Hopefully, this will result in a fumed outside and an non-fumed inside (and rim). Dark outside, light inside.

One side note, the chestnut reacted very quickly to the woodburning tool when signing, so my usually sloppy signature is especially so on this piece.

I'll post before and after pictures after extraction from the tank.

-Craig

Re: The chestnut bowl is in the tank.

#2

Re: The chestnut bowl is in the tank.

Keith Newton

>Do you have a candle or another heat source under the amonia? I thought this was what caused it to fume.

Re: The chestnut bowl is in the tank.

#3

Re: The chestnut bowl is in the tank.

Craig Daymon

>No. Especially no candle as one of the most important things about fuming is using an air-tight container.

Heat will speed the process, but I think the best way to achieve this would be to bring a light into an cooler through the drain hole and rubber cork around the wire. I have a 40 gallon cooler that I have considered rigging with such a set up but the results I have gotten have been sufficient to produce the desired effect.

The bowl is out of the cooler now and, unfortunately, the inverting of the bowl did not produce the desired effect. The whole bowl is fumed a chocolate brown, MAYBE a LITTLE darker inside than out, but not much. This could be for several reasons, 1) Not enough weight to produce a tight seal against the foam, 2) Not using an appropriate material to achieve the seal, 3) Unseen cracks allowing the fumes to penetrate into the bowl (there are 2 knots in the bowl that might have through cracks). Too bad, it would have been an excellent effect.

The pictures will be coming after I get some finish on the piece.

-Craig