New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Jet 1236 Lathe -- Good News

Posts

Jet 1236 Lathe -- Good News

#1

Brad Vietje

Jet 1236 Lathe -- Good News

Brad Vietje

>I'll admit that I have occasionally been none-too-poetic about the shortcomings of the Jet 1236 -- a lathe I own, and a model I think could be an excellent value in mid-sized lathes with a little more attention to quality control and machining tolerances -- even though that would raise the cost somewhat.

Well, 2 weeks ago the tailstock ram erupted through the aft end of the tailstock casting while I was trying to rough a small bowl between centers. When the wheel is turned to advance the ram, you are basically pushing a captured E-ring on the shaft against the back of the casting to advance the ram. Over time, the E-ring had drilled a cylinder right through the cast iron, and when it reached about 1mm thick, it just gave way. I consider myself a fairly skilled turner, and I had not overtightened it enough to bend the E-ring, so I didn't think I had abused it.

I wrote to the WMH Tool folks (they own Jet and Powermatic), and I argued that 2 other lathes I use, both about 50 years old, have had no such problems, and I thought it was a design flaw. Their response was to offer to replace the casting at no cost to me, even though the lathe is 6 or 7 years old, and I bought it used about 3 years ago.

While I still feel this popular model could use an upgrade and slight re-design, I commend the WMH Tool Group for standing behind their product. I'll be a happy camper when the new casting arrives, so I can get turning again. Seems like WMH is a good group to deal with; hats off to them.

Safe Spinning,

Brad Vietje

Thetford, VT

Re: Jet 1236 Lathe -- Good News

#2

Re: Jet 1236 Lathe -- Good News

GaryG in MD

>Brad,

As a fellow 1236 owner, I'm glad to know that. Good work. Thanks for all of us.

Gary

Re: Jet 1236 Lathe -- Good News

#3

Re: Jet 1236 Lathe -- Good News

Peter Toch

>I have seen the design of this tailstock assembly and agree that there is room for improvment. There is an easy fix that will cost you about 3 cents and prevent this problem from happening again. When you receive the new tailstock casting, put a flat washer onto the shaft of the quill such that it is between the C-ring and the casting. This will act a bearing for the C-ring to rotate against without "grinding" away the casting. Also, grease the quill assembly well, especially between the casting, the flat washer you've inserted, and the C-ring. This should now last for you to hand down the lathe to your grandchildren...assuming the rest of the lathe is up to it.

Re: Jet 1236 Lathe -- Good News

#4

I'm really bummed out now Brad

Dave Anderson Chester, NH

>The exact same thing happened to me about 10 months ago on my old 1236. I sent in digital pictures to Jet along with a a request that they replace the tailstock casting under an expired warranty. They refused and I had to buy one and have it shipped at a cost of about $90+ including shipping. Now I have a blue 1236 with a white tailstock as my spare lathe. Addenda: After 2 months and about 40 hours, I'm still thrilled with the performance of my new Jet 1642 2hp which replaced the 1236. It'll probably be the last lathe I ever buy.