New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Souped Up Bandsaw

Posts

Souped Up Bandsaw

#1

Souped Up Bandsaw

TomW in SouthJersey

>A friend gave me a Craftsman 12 inch bandsaw. I just completed fine tuning all the adjustments and installed a new blade. It had a 1/3 HP, 1750 RPM motor and would stall when cutting blanks larger than 3 inches thick.

I mentioned this to my friend and he showed up with a new motor. This one is also 1750 RPM but 2 HP. Its quite a bit heavier than the original motor so I beefed up the mounts. Pulleys are the same size.

Now it seems to cut through wood right up to the 6 inch maximum height.

Anybody see a problem using such a large motor? The manual says only use 1750 RPM but it also says not larger than 1/2 HP. Bigger is better right?

Tom Wright

Re: Souped Up Bandsaw

#2

Re: Souped Up Bandsaw

John Lucas

>Tom The main problem will be the stiffness of the frame. I had a 3 wheel 16" Delta and I did everything under the sun to make it cut better on resawing. I had the pulleys trued, I set the wheels coplaner, I stiffened up mounts and added a new motor. Put on a segmented belt, you name it I tried it. I sold it and bought a cheap tiawan 14" and immediately got better cuts. The frame was simply too weak to support the proper blade tension. Now that I've gone to a Delta 14" I see another big improvement and you can look and see how much beefier the frame is. I haven't even had time to tune this one up properly and still cuts better than the last 2.

Re: Souped Up Bandsaw

#3

Re: Souped Up Bandsaw

Fog Tanner

>You sound like a real hotrodder, "If one's good, two's better"...

If you are just using it to cut blanks, you should not have any problem. Getting close is all you really care about. The only problem you would probably run into is if you wanted to do some resawing. Your frame may not take the tension required, now that you can cut to its 6" max, and flex on you. I got tired of my Jet 14" not cutting some of the larger blanks and went to a MiniMax 16". And resawing on the Jet was a wish and get it close. There is no flex in the MiniMax frame and now I can do resawing along with cutting the larger blanks.

BTW, Trent Bosch did something like you did. He had a Jet 14" and added a 2 hp motor for the large blanks. He added some supports and an increased table area to help support the blanks. Worked finr for cutting blanks. He has since moved on to a larger bandsaw, one of the industrial saws like mine.

Re: Souped Up Bandsaw

#4

Is This a Tim Taylor Tooltime Project?

Ric

>