New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

new grinder

Posts

new grinder

#1

new grinder

Bob R WestMac Turning

>My grinder died. It was family.

Who's has a good one with a price at this time?

HELP:

Bob R

Re: new grinder

#2

Have the motor rebuilt.

Clem Wixted

>

Re: new grinder

#3

Re: Have the motor rebuilt.

Bob R WestMac Turning

>Could. But I want a 8 inch. I recieved new wheels for fathers day. Got some great kids.

Thanks

Re: new grinder

#4

Surface speed ?

Fred in NC

>Somebody correct me if I am wrong ...

The surface speed of 3560 RPM motor (usually called high speed) with a 6" wheel is 5419 feet per minute. With the 8" wheel, it is 7225 FPM.

I don't think it is the RPM that matter, but the speed at which the surface of the wheel contacts the tool.

Am I way off ?

Re: new grinder

#5

Re: Have the motor rebuilt.

Jerry Whitaker

>A friend recently took his motor from a 12in. Craftsman bandsaw to a motor rebuilder and it was going to cost $240.00. A new one from Sears cost $125.00 plus shipping and tax.

Re: new grinder

#6

My rebuilder charged $45 for a 1 hp rebuild.

Clem Wixted

>

Re: new grinder

#7

Re: new grinder

JamieDonaldson

>Buy the 8" low speed from Woodcraft for about $80(with white wheels) and save the ones you have for spares.

Re: new grinder

#8

Your right on. Surface feet per minute SFM

Kudzu

>

Re: new grinder

#9

Re: new grinder

RevDoug

>Ditto what Jamie said. I got one a few months back and it has worked flawlessly. I did have a wire fall off the switch shortly after coming out of the box, but that was a 2 minute fix. Most of that time was taking the four screws out and back in. No problems at all. I would buy another today if I was in the market for another one.

Turn 'em round

Re: new grinder

#10

Re: new grinder

Bob R WestMac Turning

>Sounds great .

Was that a 1725 rpm?

I have not purchased from Woodcraft. Is there any tricks or are they pretty much up front?

THANKS

Bob R

Bob R

Re: new grinder

#11

Re: new grinder

Devon Palmer

>Both my father and I bought the $80 woodcraft slow speed and have had nothing but problems. They both vibrate horribly - even with a brand new SG wheel. I've tried balancing, trueing the wheel with a wolvering jig mounted diamond, rotating wheels - everything. Its almost as if the shaft is bent. I'll probably end up switching back to my high speed $25 buffalo special - runs smooth as silk and takes about 3-4 minutes to wind down.

Re: new grinder

#12

Re: new grinder

Lan Brady

>I bougth the WoodCraft grinder about a year ago. It vibrated just as you mentioned. I marked the entire surface with a sharpie. Then I dressed the wheel slowly until all the black was gone. I lost about 1/4" diameter, but the grinder is balanced now. I have not lost another 1/4" in a 100 dressings since.

Lan