New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

"Shop built" scroll chuck?

Posts

"Shop built" scroll chuck?

#1

"Shop built" scroll chuck?

Eaglesc

>I have not gotten into bowls other than a small cup without a handle.I do pens.

I do some glue ups that I feel would be drilled more accurately on the lathe rather than the DP.

In reading the articles section I came across the Long worth chuck that with its' self centering feature I would imagine is much like a scroll chuck.

Here's the question.

Has anyone made a scroll type chuck or any other type chuck that can be used repeatedly to hold 3/4"- 1" square blanks for drilling on the lathe out of wood or other commonly used materials rather than metal?

I have turned tenons and used a Beall Collet but would like to eliminate the tenon step.

Any ideas?

Re: "Shop built" scroll chuck?

#2

Re: "Shop built" scroll chuck?

Barry Irby

>I don't think a Longworth Chuck will work for you. They have a series of spirals (eccentric?) that cause the jaws(?) to open and close. I don't think they can close down far enough to grip a 3/4" piece and would not hold it tightly enough to support it for drilling.

Do you have a scroll chuck? You can buy small jaws for that and on a Nova you can remove the jaws and grip small piece with the slides.

Another idea is to use something like a belt sander to grind a taper on one end, as if you were sharpening a pencil and then drive it directly into the taper in the shaft in the headstock. The you can bring up the tail stock enough to see if it is centered on that end. Tap it into position, put the drill in the tail stock and drill it. I turn finials this way and usually have a piece about 5/8 to 3/4 long in the No. 2 MT. You could part that off or use it as part of the blank for a pen. If you part it off, your blank might have to be a little longer.

Wonder if you could make a little square "socket" with a Morse taper drive on it and mount it in the headstock. Then you could insert the blank into it and bring up the bit and drill it that way.

Re: "Shop built" scroll chuck?

#3

Re: "Shop built" scroll chuck?

Eaglesc

>I don't have $croll chuck.That's is why I wondered if a shop built one is possible.

As far as turning or sanding the taper and useing the headstock Morse taper,As I said in my post I do have a Beall collet set and I could continue using that.

Thanks for the suggestions though.

Re: "Shop built" scroll chuck?

#4

Re: "Shop built" scroll chuck?

john Lucas

>How about creating a faceplate with a V glued on the front to center the piece. Then another piece of flat wood on top. You place the pen blank in the V then push a wedge between the pen blank and the flat piece of wood above the pen. This would be very quick. It would require the pen blanks to be very close to the same thickness or the hole would not be centered but if you chuck was built accurately the drilled hole would be true.