We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
>I have been searching for a source of 2 to 3 inch diameter Forster bits with a Morse taper shaft and an over-all length of 16". I have not found a source on one ready made but I have found a company that will make them. I'll have to have a rather large number made to get the cost reasonable. Anyone else interested in these?
>Yes, but I would have a greater desire for them in the 1-2" range. Still, I'd hardly pass up the opp to spend money on an unusual, expensive, and rarely used tool.
>I bought a No. 2 MT extension. It's 8 or 9 inches long and was available from a machinist supply catalog. There were several lengths available and several brands, ranging from about $8 up to about $20. I find it very handy for putting the live center against a turning and keeping the tail stock out of the way. It's male on one end and female on the other. I think you could get them in any combination of taper sizes, but I have a 2 to 1 adapter and use that when I need it.
If you can find shorter bits this would stretch them out. Its about and 1 1/4" in diameter. As long as you bit is bigger than that, you could string together as many as you wanted. If you are drilling a hole larger than the chuck, you could just use a chuck with a MT taper and use a regular bit. I bet you can get a No. MT that is threaded to receive your chuck.
I can post a picture if you want. A machinist ordered it for me and I could find out exactly where it came from.