We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
>I am turning or [should I say sanding] a very punkey piece of spalted maple. No commits about sanding. I rough turned it but tearout is realy bad, so I started sanding . The sanding is removing the soft wood to fast. So I soaked it with thinned lacquer, to firm up the wood. My question Is, is this a good way to firm up wood or does anyone have a better way of firming up punkey wood. Thank you Greg
That's my preferred method although I haven't tried the diluted yellow glue method. The thinned lacquer soaks in really well and firms up the wood. It does clog sandpaper worse than not coated wood so I try to use cutting tools as long as possible.
If it's just a small area that's punky I'll use Thin CA glue but it's so expensive I use lacquer mostly.
don't be embarrassed by needing sandpaper. Sometimes it's just the best tool for the job. My friend who is a production turner doesn't waste time trying to fine tune the finish with a cutting tool. He graps the 120 grit and cleans up the tool marks and then switchs to 220 and he's done. He'll turn a candlestick in half the time I do and I'm pretty quick.
Minwax makes a product called Wood Hardener. I have used it in the past with good results. Terry Daniel used it in gallon quantities on one of his big poplar bowls.
I don't know how the price compares to lacquer, but I would assume that it is about as cheap. I know that TD is not one to waste a dollar if he doesn't have to. 8^]
>Give it a glue bath. Soak it in a mixture of Weldbond and water. I use 4 parts water to 1 part glue. Soak it for about an hour and let it dry for 24 hours.
The reason I use Weldbond is because I also do ths with stone I turn and I needed a glue that dries cleal