Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

beveled blades don't like end grain

Posts

beveled blades don't like end grain

#1

beveled blades don't like end grain

Bill Tindall, E.Tn.

It has been reported extensively that chiseling end grain puts stress on beveled edges that can deform or chip them. More recently this issue was discussed here for shooting end grain. Indeed as I have become more gentle entering a shooting plane to an end grain cut the beveled edge has held up better.

As reported on the main board I have had to refit all the drawers for the desk I am building. The trip of the drawers from the <40% RH shop to a conditioning period at high humidity resulted in all 8 binding. Even the side clearance had to be adjusted on some. Never had that happen before.

As a result I have been doing more drawer side planing than ever before. It had not crossed my mind that the drawer front pins presented the same situation as shooting end grain. With enthusiasm I was planing across the pin ends with these long drawer side cuts . Soon tracks were showing up that even I became aware of. I destroyed the edge of a PMV11 blade sharpened at 30 degrees. I did not need the 10x lens to see divots missing from the edge.

Lesson learned. During an extended cold spell with the shop at <40% RH go hiking in the snow instead of building drawers :)

Re: beveled blades don't like end grain

#2

now you know...

David Weaver

..why I faffed around finding the failure angle for plane blades, and why I don't think it's 30 degrees.

XHP also does lack toughness somewhat, but the issue with stringy end grain isn't just a toughness issue, it's strength. You an manipulate the two variables like hamburger/cheesburger.

do you want lines on the work from folding or lines from chipping?

33 degrees or so is where this damage decreases a great amount and this is why when I was doing the iron test, I mentioned not caring that much about squeezing extra clearance out of a blade because doing so makes it more difficult to get practical extra footage without edge damage, and the edge damage greatly increases hone damage.

Same also was the impetus for the edge roll on stones that became the unicorn (though even those have to be managed based on material - if you have a pleasant softwood, as you found, the uni can crush fibers - the chisels as I sent them to you probably wouldn't have had a problem with cherry where I cut most dovetails but everything can be thinned back).

What you're seeing is also why tests like mine can present a biased answer. Yes, XHP lasted twice as long as O1 in clean wood. No, if you use the plane irons in varied situations, you can't get the same results (interrupted cuts, too much end grain, over joints with glue in them). starting a blade askew with a bump is the best way to limit edge damage, but when planing something like that, having a fast honing or fast grinding blade is even better.

In making daughter's bed last year, I used a lot of SYP and white pine. The cheap buck bros blades were dominant for that because of how fast they sharpened and how much better they stayed ahead of the damage without lengthening the sharpening cycle.