Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Cap irons have always needed work

Posts

Cap irons have always needed work

#1

Cap irons have always needed work

david charlesworth

Having assisted hundreds of people to set up their planes, I am quite clear that cap iron front edges need fettling.

I am also clear that very few of the new or old ones we saw were fit for use.

Blunt square edges, chips lack of fit to blade back, were all issues to be checked.

On the u/s of front edge we checked fit and clearance angle.

On the top side we created a small bevel at 45 degrees and polished the surface.

Bill Tindall's photo in previous thread was very helpful.

Now I do not expect new C/Bs to be ready for use, so making minor adjustment to L-N new style models is not a hardship. Once fettled they work extremely well.

I have used the KK recipe (50 degree C/B) to plane the most refractory of

timbers, and it works. I just wonder why this knowledge was so little known during my career.

Best wishes,

David

Re: Cap irons have always needed work

#2

Re: Cap irons have always needed work

David Weaver

preparing a cap iron fully requires some level of polish on the front end, the tight joint with some relief that you're speaking off, and some discretion.

Since the caps are generally mild steel (I think woodcraft sells one that's minimally hardened, but they take on no appreciable wear that I've seen, so I don't see the virtue in that), this isn't a minor process and I think it's reasonable that LN sends a cap that's not fully prepared.

The real complication comes in serving a market and providing something with instruction that suits them. I don't know who their target market is, but it's going to include beginners as that's life.

As to the loss of use of the cap iron, in the states at least - it speaks to two things:

1) lack of economic interest

2) lack of desire by people who had no economic interest (hobbyists)

In the 1990s, the few I knew who were hobby woodworking were fine with site table saws, a lot of red oak and a healthy router roundover on everything.

We went to williamsburg for 3 days ever other year or so when I was a kid, but it didn't begin to occur to me that someone would work like people were working in their shops as a hobby or even as a business. There were still local furniture factories in central PA and any small shops were plain furniture, sometimes sold unfinished. Cheap imported furniture ended both of those.