Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

donkey ear

Posts

donkey ear

#1

richie croce

donkey ear

richie croce

making small mitered box. wondering how some proceed with hand tools. any thoughts on making donkey ear for truing miters.

Re: donkey ear

#2

Re: donkey ear

david charlesworth

Some form of Donkey's ear will help to get perfect miters.

Ideally this should have a right and left handed function.

David

Re: donkey ear

#3

richie croce

NM. search found info.

richie croce

NM.never mind; found enjoy on search

Re: donkey ear

#4

Re: donkey ear

David Weaver

depends on the level of perfection needed. I bought a miter jack from England a couple of years ago, it's close to dead perfect and was cheap enough that it made no sense to try to duplicate it or deal with a type of fixture that may not be good for large and small pieces.

A With some hand touch, minor tuning can be done freehand either with planes, floats, gouges and chisels or with a glass sandpaper lap where the sandpaper is PSA roll (no part of it can come up and dub work).

The ability to tune things freehand to fit will save time and will also allow you to get out of absurd spots that you shouldn't have gotten into, like this:

https://i.imgur.com/lFcCLcI.jpg (notice that the miter meets in the center of the front moulding and not in a neat corner. I had to cut the flat part of the fit fat and then clean it up by hand, but it wasn't that difficult to do - far easier than it would've been to come up with some combination of fixtures and keep test fitting.

Re: donkey ear

#6

richie croce

Re: donkey ear

richie croce

NM; thank you all

Re: donkey ear

#7

More versatile version

Bill Tindall, E.Tn.


I don't recall who on WC gave me this idea for a "donkey ear" and maybe it isn't one. But it will trim any length miter and it is easy to build. I have used it on many projects.

Re: donkey ear

#8

richie croce

Re: More versatile version

richie croce

I like it ;thanks

Re: donkey ear

#9

question

Bill Tindall, E.Tn.

is the picture sufficient for you to copy design? I can take others as needed.

The person I got it from made frames for painting that could be many feet on a side. Hence, the need to shoot with the board not sticking up in the air.

Re: donkey ear

#11

NM: No need I got it thanks


Re: donkey ear

#12

Re: The fixture is by Robert Wearing.

William Duffield

You can find the drawings and explanation beginning on pg. 101 of "The Solution at Hand", the definitive collection of Robert Wearing's articles, published by Lost Art Press. However, I can't find plans for it in "The Essential Woodworker" also written and illustrated by Wearing and published by LAP.

There are several other books written by Wearing referenced here, that you will need to find on your own, if you want them:

https://blog.lostartpress.com/2020/04/28/robert-wearing-1921-2020/