Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Unicorn for plane blades *LINK*

Posts

Unicorn for plane blades *LINK*

#1

Unicorn for plane blades *LINK*

Chuck Bjorgen

David Weaver posted a new video on some tests he did with the Unicorn process for plane blades yesterday. I found this on YouTube quite by accident probably within an hour after he posted it. I had read with interest the discussion about buffing chisels but the plane iron video he did really got my interest up so I immediately ordered some buffs from Amazon with the idea of using my cordless drill or drill press to power them. I will definitely try this now.

Title of video is: Unicorn make junk plane irons pearls

Thanks, David.


https://youtu.be/-c37u1UJIVI

Re: Unicorn for plane blades *LINK*

#2

long video, so...

David Weaver

..I added some time references in it in the details. Too much talking while sharpening makes doing two irons something close to 4 minutes. Without talking, it would be more like 2 minutes for two.

I decided to do two so that it was clear that you can do the process twice and get the same results (I'm too lazy to shoot videos several times, but one never knows - doing two instead of one is better proof).

I may not be that smart, definitely not organized, certainly not pretty....

....but I can really beat a dead horse, and sometimes it takes the last whack with a stick to get another group of people to try something.

Re: Unicorn for plane blades *LINK*

#3

Re: long video, so...

Chuck Bjorgen

It worked for me :)

Re: Unicorn for plane blades *LINK*

#4

Re: long video, so...

Michael Todrin

I thought it was a great video David and appreciate you posting it. I played around with an old Millers Falls iron today and got similar results. Super fine shavings, bright finish and good durability. In short; as advertised, stunning performance and super easy preparation.

Re: Unicorn for plane blades *LINK*

#5

Re: long video, so...

David Weaver

Thanks for confirming your results!

If I put something up and say it works, one person will try. If someone else has success with it - five people will try based on that. It's much more convincing.

I don't think Bill ever tries anything I write about until someone else has success with it :)

Re: Unicorn for plane blades *LINK*

#6

Re: long video, so...

Michael Todrin

Another note on the iron I used is that it is almost used up and I had just replaced it with a v-11 iron as I suspected it was starting to get very soft and would to hold an edge. I suspect it was very close to where the heat treat had stopped.

This is such a valuable shortcut to getting an amazing edge on both plane and chisel. You have done us all a valuable service sharing it. I am glad to use it and confirm its utility.