Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

nose bits

Posts

nose bits

#1

justin ball

nose bits

justin ball

Anybody got experience or a link to a video about sharpening nose bits? Bit like a spoon bit, but it's got this tiny cutter. Any history on them? I touched one up and it went ok is soft wood, but I don't see it being a hot seller.

Re: nose bits

#2

Re: nose bits

Charlie

Put loose grit abrasives (dry, paste, whatever you have) in a fairly shallow hole you started with the nose bit, add a few drops of oil if using dry abrasives, then drill the hole deeper. Do it several times.

Re: nose bits

#3

justin ball

Re: nose bits

justin ball

Are you sure this works? Have you done this and consistently got good results? I mean, this sounds great and it would clean it up, but also sort of like it would blunt it....

Re: nose bits

#4

Re: nose bits

David Weaver

I'm assuming that you're talking not about the shell type bit that looks like a thumbnail gouge (not quite, but sort of like that) , but rather the one that has a shag of metal bent in toward the center of the cut?

If the bit can be filed, you can just clean up the geometry on the outside if losing clearance bothers you.

Coulters on plows get the same kind of wear that charlie is advocating abrading onto the bit, and they just wear smaller and smaller but usually have a keen leading edge.

Re: nose bits

#5

Re: nose bits

Charlie

It worked for me, made a noticeable difference. I've never owned a brand new one, so I can't compare it to that. This is an old 'trick' that's been around forever I'm sure. Can't remember where I first came upon it, but it was probably in an old Fine Woodworking magazine.

Re: nose bits

#6

Re: nose bits

Charlie

Works on gimlets too...

Re: nose bits

#7

justin ball

Re: nose bits

justin ball

Gimlets too? I got an evening's fun to look forward to. Now to find some metal polish, or valve lapping compound or something...I'll have to keep my camera with me...

Re: nose bits

#8

Re: nose bits

Charlie

Auger bits as well to a point. Don't go crazy with any of this or use too coarse a grit or you'll lose the outside diameter/clearance the particular bit needs to work.

Re: nose bits

#9

justin ball

Re: nose bits

justin ball

OK. I buy my auger bits 90% dead at car boot sales, and then use a set of small files to clean up. When I finally get fed up with them, I stick them in the bucket garden pots, screw end up. It stops the cats from crapping in the tomatoes. (Roofing slates split long ways and up ended like a ring of standing stones also works). One day I might buy a NEW one to see what I've been missing.

Re: nose bits

#10

Fine woodworking email tip material...

David Weaver

...absolutely word for word. They'd never print it, but it's pure gold :) :

"I buy my auger bits 90% dead at car boot sales, and then use a set of small files to clean up. When I finally get fed up with them, I stick them in the bucket garden pots, screw end up. It stops the cats from crapping in the tomatoes."