Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Derek's Brass Dovetail Marker

Posts

Derek's Brass Dovetail Marker

#1

Derek's Brass Dovetail Marker

Don Stephan

Derek

Visited your inspiring web site www.inthewoodshop.com looking for bowsaw plans (which I didn't find) but stopped by to read a couple times your article on making brass dovetail markers. My question, how accurately can the angles be measured, and how to measure them that accurately?

Thanks in advance.

Don Stephan

Re: Derek's Brass Dovetail Marker

#2

Jack Guzman from Maine

Re: Derek's Brass Dovetail Marker

Jack Guzman from Maine

https://toolsforworkingwood.com/store/more/bowsawdesign.html

The link is to Toolsforworkingwood's article on bowsaws.

Re: Derek's Brass Dovetail Marker

#3

Re: Derek's Brass Dovetail Marker

William Duffield

Here is an archived copy of the original bowsaw plans by BugBear. Just about all modern bowsaws started here.

https://www.oocities.org/plybench/bowsaw.html

A hint: If you convert the dimensions from metric back to the original imperial units, they make a lot more sense.

Re: Derek's Brass Dovetail Marker

#4

Bowsaws

Jim Matthews

To the OP -

Drop me a line if your just looking for bowsaws to use.

I have several, just gathering dust.

Jim

Re: Derek's Brass Dovetail Marker

#5

Making the Brass Dovetail Marker *LINK*

Derek Cohen (in Perth, Australia)

Hi Don

You can see that I am using a sliding bevel in this picture ...


I made four angles choices: 1:5; 1:6; 1:7; 1:8

Each of these is a ratio, for example, 1” across and 7” down.

On a piece of paper/MDF/ply, scale off 8” in one inch increments along a verticle axis, and a single 1” mark along the horizontal.

Now use the sliding bevel to connect the 1” to whichever ratio you intend to make. That creates the angle you see in the photo.

Regards from Perth

Derek


article in question

Re: Derek's Brass Dovetail Marker

#6

Re: Making the Brass Dovetail Marker

Don Stephan

Thanks for the prompt reply DC. When I read a couple times the section of your article describing fussing with slightly wrong angles I assumed you were using some high tech digital scale, especially with such short edges.

Still wish we could find some wonderful down under expressions in your articles. Re-reading a PG Wodehouse story and smiling over the numerous examples of British slang, even if I don't understand most.