Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

black and gold rocker

Posts

black and gold rocker

#1

Jack Guzman from Maine

black and gold rocker

Jack Guzman from Maine

I am repairing a broken antique rocking chair. It was stained and laquered originally. Due to the fact that I had to use wood filler in places and new wood to do some splints and replace one rocker I am going to paint it. I would like to paint it gloss black with gold trim on some of the leg beads but I can't use volatile chemicals because the shop is downstairs from my house and would stink up the house. Is there a way to achieve gloss black with water based paint?

If I can't do this I will use milk paint and paint it like I would paint a windsor chair.

Re: black and gold rocker

#2

Re: black and gold rocker

David Weaver

I know nothing about chairs, but target makes a water-based black lacquer product.

I have a can of it, but haven't used it yet.

https://www.targetcoatings.com/product/emtech-em6600-wb-raven-black-lacquer/

It may be a little bit too modern "techie" for chairs, though.

I've had good luck with the WB clear of the same family when using a crosslinking additive.

Re: black and gold rocker

#3

Jack Guzman from Maine

got it

Jack Guzman from Maine

Thanks David,

I bought a quart. If I don't like it for this project I am sure I will find a use for it .

Re: black and gold rocker

#4

solution

Bill Tindall, E.Tn.

Get chair and spray can warm. Go outside and spray. Move chair inside. Done.

I spray conversion varnish outside (for flammability) all winter, not that we have had much this year. Flash the solvent and move indoors. The heat capacity of the wood will flash the solvent readily.

I remain surprised that people object to a whiff of wood finishing solvent. Used to be houses were varnished and painted with solvent based paint. Smelled for days I expect. And then there is filling the gas tank.

Re: black and gold rocker

#5

Logic doesn't matter...

David Weaver

....last year, I brush-lacquered a guitar body and hauled it outside (in the snow - snow on the ground, not snowing at the time) after reading that cold temperatures wouldn't interfere with the brush lacquer curing (or whatever the appropriate evaporative term is).

The next morning, I hauled the guitar body in to prevent bird crap damage and the faint smell of lacquer remained in the garage. I got a gigantic brow beating from the mrs. over that. "kids will get cancer later in life because you just have to make things you don't need". That type of stuff.

You can't smell the WB finishes that I spray, but just the act of spraying them causes friction. These are in the attached garage - and something with a strong odor like brushing lacquer will make it into the basement in very small amounts (I can't smell it upstairs at all) because the house isn't airtight - hopefully it never will be.

I've learned to get along with crosslinked water-based finishes, shellac and varnish. Nitro isn't actually something I even like the look of, so it's not that big of a loss, but the reaction was outsized to say the least.

Re: black and gold rocker

#6

not saying!!

David Weaver

that this applies to jack by any means!!! I think there's more leniency in most places, but my wife works in health care (she sees a lot of irresponsible people and doesn't manage to separate that cohort from the average individual) and we live in the burbs, so there are plenty of other helicopter mothers to bounce ideas off of.

Re: black and gold rocker

#7

Re: solution

Wiley Horne

Bill and all,

Do you have a favorite spray can paint brand? I have used Rustoleum Painters’ Touch, and liked it, because it is oil-based, and I could hold a brush in one hand and the can in the other—if I overspray I can brush out the run and the paint will relevel on its own. You prolly have better technique than me and don’t get runs.

Wiley

Re: black and gold rocker

#8

Jack Guzman from Maine

Not an option

Jack Guzman from Maine

What I have is a ladderback rocker with turned legs and stretchers. I would freeze before I could get the whole thing sprayed properly. Also after spraying the odor would still make it's way into the house. I have a wood shed I can paint in when it isn't so cold but this time of year it isn't practical. I have tried what you suggest. It doesn't work. The smell still fills the house.

Times like this I wish I had an auxiliary building. I could wait to paint it for warmer weather but I want to get this one finished now.

Re: black and gold rocker

#9

And it's going to get colder the next couple days


Re: black and gold rocker

#10

Re: black and gold rocker

Philip F Duffy

Jack, your original answer seems to me to be the correct solution. I love the Milk Paint look and finish and cover it with one coat of gloss Wipe on Poly. P

Re: black and gold rocker

#11

Jack Guzman from Maine

Re: black and gold rocker

Jack Guzman from Maine

You may be right. I got the paint today and it calls for spray application. I have no spray equipment. I have to see how it looks with a brushed application.

Re: black and gold rocker

#12

Re: black and gold rocker

Philip F Duffy

Jacl. Try a foam brush and tell us how that works out, please. P.