Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

preparing cast iron for sharpening plates

Posts

preparing cast iron for sharpening plates

#1

preparing cast iron for sharpening plates

Bill Tindall, E.Tn.

Diamond embedded in cast iron will scratch anything including diamonds, which is how they are faceted. Any machinist manual will document this means of polishing hard tool steels. Surface grinding is a preferred way to prepare the plates, which may involve sending them to some kind soul that has access to a surface grinder. Plates are heavy so a flat rate box is preferred. The PO can destroy flat rate boxes with heavy stuff inside and only miles of fiber glass tape may keep the plates inside.

A better option for a woodworker is to armor the plates inside the box within a box. The lid must be secured. A dozen of so screws will be adequate and 1/2" strand board on a 6/4 frame should be sufficient to resist the PO attempts at destruction. ;) :)



Inside, 3 shiny smooth cast iron plates ready for service.



Thank you Bruce........

My apologies to whoever shipped their ceramic coffee mug next to this package.

Re: preparing cast iron for sharpening plates

#2

worth doing...

david weaver

..I've used several manners of commercially available iron and steel plates, but none have been close to as good as the plate that phil sent me as part of the iron testing.

I still haven't figured out how to sharpen something on the cast plate every single time freehand without any defect, but the little nits that occur would never bother anyone else and are so tiny that they have no effect on longevity.

My cycle time using a diamond hone and the cast plate is no less or more than a simple iron on a medium that I find a little easier to use (low side just over a minute to two minutes for something with issues that need to be removed).

If those plates weren't fastened in a frame, I can't imagine how much damage they could do to themselves or the box in regular packing. They're potentially missiles.

I like to flatten planes, and have enjoyed learning to flatten infills with a file to flatness similar to premium planes, but the effort involved in filing slightly hollow and then lapping and checking just isn't worth the trouble with a flat plate.

Anything with slots in it is unsuitable (those types are generally flat), most of the inexpensive japanese kanaban aren't actually flat (and they're gummy mild steel), etc.

Re: preparing cast iron for sharpening plates

#3

Re: preparing cast iron for sharpening plates

Bruce, a MN Galoot

I have to admit that I had a really good laugh as I was making that box. I saw it as a challenge. Some time ago, Abom79 posted a video that showed something that had been shipped and improperly crated. It was destroyed. I took that as a lesson.

I hoped your delivery person worked out regularly.. the plates alone weigh in at more than 14 lbs, and the total package was more than 20.

Re: preparing cast iron for sharpening plates

#4

Re: preparing cast iron for sharpening plates

E Phillip Smith

You should have seen the original shipment of raw cast iron. It was six bars long enough to be split in have and make a dozen lapping plates. It was wrapped in cardboard and tapped to make a cube, no padding or box. Label slapped on and shipped by UPS. I always wondered how much stuff it broke in transit.

Re: preparing cast iron for sharpening plates

#5

Re: preparing cast iron for sharpening plates

John in NM

Bullet casters are always shipping flat rate boxes of lead wheel weights around. A medium flat rate has a limit of 70 lbs!