Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

The Harlequin side table: rounding the dovetails

Posts

The Harlequin side table: rounding the dovetails

#1

The Harlequin side table: rounding the dovetails

Derek Cohen (in Perth, Australia)

This may also be a break from tools and blades :)

We left off with the drawer dividers a dry fit in the case ...


And then this was pulled apart and the case glued up. After a clean up, the ends were looking a little tidier ...


Now we've been through this together with the Jarrah coffee table, but for those who want to know how ...

The ends are marked (with a washer) ..


The aim is the remove the waste progressively to the lines ...


This is quick to do with a low angle jack ...


.. and finish with a block plane ...


Now finish with sandpaper - 80/120/240 grit ...


The completed case ...


I spent a few hours today turning a few legs. Rather than show the prototypes, I am hoping that I may have enough time to complete them tomorrow - I have the afternoon off! :) - and then I will post more photos.

Regards from Perth

Derek

Re: The Harlequin side table: rounding the dovetails

#2

Re: The Harlequin side table: rounding the dovetai

Howard Pollack

As always, nice work Derek! -Howard

Re: The Harlequin side table: rounding the dovetails

#3

Jack Guzman from Maine

Exploring alternatives

Jack Guzman from Maine

Derek, I like the fact that you share your builds in such comprehensive detail. An added plus is that you are exploring methods of dovetail jointery that have not been demonstrated before in a forum such as this. thank you---Jack

Re: The Harlequin side table: rounding the dovetails

#4

Agreed

Frank D. in Montreal

I dont ask many questions or give much encouragement, but I greatly appreciate reading Derek's posts. Thanks Derek!