Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A coffee table for my nephew - #4

Posts

A coffee table for my nephew - #4

#1

A coffee table for my nephew - #4

Derek Cohen (in Perth, Australia)

I assembled the carcase today. This began with glueing the one end and, while that dried, fitting the sides of the drawer box ...



Someone predicted that this glue up would be interesting. Was it ever.

I had this plan to glue the ends, attach the drawer box, and then simply drop the top side into place. What could be easier?

Except ... I realised as I positioned the drawer box dividers in their stopped dados - and was just about to glue in the other end - that the ends were tails and the top section had pins ... and they needed to be slid in horizontally, not vertically! The order of assembly should have been: fit drawer box to open base, add top section, now add one end and then the other.

I removed the drawer box parts, and attached the top panel to the already glued end. Lifting the top at an angle, the drawer box dividers were wiggled in. And then I discovered that they were 10mm too high!

Oh hell (or some other descriptive) .. I propped up the top panel, quickly calculated how much needed to be removed on the table saw, did both dividers, rebated the ends again ...


... it fits ... (phew)

.. up ended the monster (which weighed a bloody ton, but I was now a demon possessed of desperation strength!), glued in the last side, and squared the carcase ....


And everything is square ...


I'll clean it up tomorrow, and then start on rounding the ends.

Regards from Perth

Derek

Re: A coffee table for my nephew - #4

#2

Re: A coffee table for my nephew - #4

Tony Wilkins

I can’t remember if this was discussed anywhere — the choice of mitered through dovetails as opposed to a secret mitre or double lap dovetail?

Re: A coffee table for my nephew - #4

#3

Jack Guzman from Maine

Been there...

Jack Guzman from Maine

I know that feeling. Moving right along,concentrate on the details and then a whoops pops up out of nowhere. Instant improvisation. You recovered well Derek. Thanks for sharing your progress.---Jack

Re: A coffee table for my nephew - #4

#4

Re: A coffee table for my nephew - #4

Derek Cohen (in Perth, Australia)

Secret mitred dovetails ... Tony, I wish I had thought of that before I glued up! Just kidding. I rejected them early on as cutting away at the ends to create a rounded profile will expose what lies inside.

Regards from Perth

Derek

Re: A coffee table for my nephew - #4

#5

Re: Been there...

Derek Cohen (in Perth, Australia)

I seem to do a lot of "recovering" each time ... :\ Thank you Titebond hide glue for a long open time and reversibility.

Regards from Perth

Derek

Re: A coffee table for my nephew - #4

#6

Re: A coffee table for my nephew - #4

AZ in Colorado Springs

Oh, wow! What an adventure, just in the glue up. No dry fitting everything ahead of time?

Re: A coffee table for my nephew - #4

#7

Re: A coffee table for my nephew - #4

Derek Cohen (in Perth, Australia)

As I mentioned to Bill, I did a dry fit, but only the parts separately. The problem with fitting and refitting Jarrah is that it is fragile/brittle and the repeated disassembly can lead to breakage (as it was, one end piece cracked, and I had to repair it).

Regards from Perth

Derek