Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Coffee Table for my nephew - #3

Posts

Coffee Table for my nephew - #3

#1

Coffee Table for my nephew - #3

Derek Cohen (in Perth, Australia)

A few progress shots.

Before beginning on dovetailing the ends, stopped dados were marked out for the drawer case. The lower- and upper panels were clamped together and a MDF template of the drawer case set in position...


Marked out, chisel walls made ...


... to guide the saw cut ...


Then chiseled ..


... and routered out ...


Following the method outlined previously, the two ends and the top were joined with mitred through dovetails ...


One edge ...


.. and the other side ...


The plan now is to size the drawer case sides before dovetailing and joining the lower panel.

In the photo below, the dados are checked for size with a 10mm wide template ...


An MDF template checks the case sides are parallel ...


At the far end is another MDF template to size the drawer case sides ...


That's it for now.

Regards from Perth

Derek

Re: Coffee Table for my nephew - #3

#2

Re: Coffee Table for my nephew - #3

Tony Wilkins

I see you used an azebiki to saw the sides of the housing joint. That’s a tool I’ve often considered to get for that purpose but haven’t pulled the trigger. Can I get your thoughts on it?

Re: Coffee Table for my nephew - #3

#3

Re: Coffee Table for my nephew - #3

Derek Cohen (in Perth, Australia)

Hi Tony

I think the azebiki is a great and useful tool. I have used it for stopped dados, even stopped rebates. It has been able to produce a clean enough cut to form a cut out in the middle of a panel. For me, it is an essential tool.

Regards from Perth

Derek