Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Lee Valley spokeshave

Posts

Lee Valley spokeshave

#1

Lee Valley spokeshave

Jeremy Osner

Hi all, I'm getting back into woodworking after a couple of years not doing any.... Wonder if anyone has encountered this issue with a Lee Valley spokeshave: when I try and shave wood, the blade pops out the back. I tried putting the blade back in and really torquing down on the thumbscrews, but after a few strokes the blade pops out again. Any ideas what I'm doing wrong?


img

Re: Lee Valley spokeshave

#2

Is this the aluminum bodied black one?

Bill Houghton, Sebastopol, CA

I've had that happen, too, on that shave (the one pictured below). It's not, in my opinion, their best design.


img

Re: Lee Valley spokeshave

#3

Re: Is this the aluminum bodied black one?

Larry Barrett

I agree, not their best design. Take fine shavings and it will work better.

Re: Lee Valley spokeshave

#4

Re: Is this the aluminum bodied black one?

Jeremy Osner

Yep, that's the one. Thanks, guess I will try adjusting it finer.

Re: Lee Valley spokeshave

#5

Re: Is this the aluminum bodied black one?

Jeremy Osner

It's funny because I've had good experiences with this tool in the past. This is one of my first times picking it back up and I reckon I have forgotten a lot... Also the wood here is hard maple, I think when I've used this tool in the past it was mostly with softer woods.

Re: Lee Valley spokeshave

#6

Re: Is this the aluminum bodied black one?

Rob Lee

Hi Jeremy -

What you are seeing is two finely finished surfaces not having enough friction between then....

If you rough up the mating surfaces with some sandpaper - perpendicular to the movement direction - it will solve the issue you are having....

Cheers -

Rob

Re: Lee Valley spokeshave

#7

Re: Is this the aluminum bodied black one?

Jeremy Osner

Thanks Rob, that sounds like a great idea.