Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Drawing up and marking out *LINK*

Posts

Drawing up and marking out *LINK*

#1

Drawing up and marking out *LINK*

Derek Cohen (in Perth, Australia)

The topic was raised elsewhere about the desirability of an Incra T-rule (the one with the million little holes to guide a 0.2 pencil - link below). I looked at this square and recalled that I've had one of these on my shelf for over 10 years, and that I had used it once or twice only ever. It looks a great idea, but in practice is too fiddly for me.

It occurred to me that perhaps I look at drawing differently to others, and so I thought that I would throw this out here for viewpoints ...

In practice, also, I do not use a scale to measure much (after drawing up to life scale, which acts as a story board). Usually, I transfer dimensions with a divider, and then run them off with a cutting gauge - which is why I have so many gauges (I'm sticking to that story! :) ).

Here is my current project, an apothecary chest - making a template for laying out the vertical and horizontal dividers. The apothecary chest is complicated by having a curved front ...



This is the curved front (but not the template, which was made with a trammel to achieve a true curve) ...


Each one of these points was marked with two dividers (no rulers) ...


I draw onto 6mm MDF sheets. It is cheapish, and it durable - It will take being scraped if needed (to remove marks), a divider can leave pin marks (to which to draw), and a cutting gauge will leave clean lines. Later, the templates may be stored for another day.

Regards from Perth

Derek


Incra Precision T-Rule

Re: Drawing up and marking out *LINK*

#2

Re: Drawing up and marking out

Howard Pollack

Thanks Derek, this is helpful. -Howard

Re: Drawing up and marking out *LINK*

#3

Re: Drawing up and marking out

Hank Knight

Derek,

For complex projects I do much of my layout the way you do. I sketch for the basic design and then draw out full scale on paper. I make story sticks, take measurements and set gauges from the paper drawing. The only time I make a template is when I need to faithfully reproduce some non-linear aspect of the design - a curve or a profile - or use for reproducing multiples of some part of the piece, like legs. I find that I can solve many problems with full scale drawings before they get to the actual wood.

Hank

Re: Drawing up and marking out *LINK*

#4

Re: Seemed Like a Good Idea at the Time

William Duffield

I have one of those, 6" Imperial. I also don't find much use for it. I have one of their protractors too. I built a box to protect both of them and put it in a drawer, where they remain protected*. For measuring angles, if I need to measure angles in degrees instead of rise and run, I prefer using the protractor head on my Starrett 12" combo square, or this one from Sterling Toolworks

http://www.sterlingtoolworks.com/store/#!/Precision-Protractor/p/56363792/category=12516967

or even one of these from Wixey

http://www.wixey.com/anglegauge/index.html#wr365

More often lately, I've been trying to minimize my use of arbitrary units of measurement, in favor of the concepts promoted by Jim Tolpin and George Walker in their LAP books.

*just a little sarcasm