Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Adze handle

Posts

Adze handle

#1

Jack Guzman from Maine

Adze handle

Jack Guzman from Maine

I bought a hollowing adze from a maker in England. I couldn't find one in the US. The adze is a well made tool. It was hand shaped by a blacksmith. It does the job well. The only problem I had with it was the handle. It appears to be a piece of ash that was shaped by some sort of machine. The ergonomics of it are fine but it is just plain ugly. After using it to build one chair I couldn't stand it any longer and had to build a new one. Not particularly elegant but beautiful in my eyes. The new one is hickory.---Jack

Re: Adze handle

#2

Nice work on that handle


Re: Adze handle

#3

Jack Guzman from Maine

thanks


Re: Adze handle

#4

Re: Adze handle

Bruce, a MN Galoot

If it’s good looking but doesn’t work for you, it’s not much good, is it. Yours is great!

Re: Adze handle

#5

Re: Adze handle

Derek Cohen (in Perth, Australia)

Jack, you're an experienced chairmaker, especially carving Windsor chairs. I note that this adze is an in-cannel. Are you planning on converting it to out-cannel, or are you happy with it this way?

With regard the handle, what do you like about the shape?

Oh, and I do prefer your treatment to the original.

Regards from Perth

Derek

Re: Adze handle

#6

Jack Guzman from Maine

poor quality picture

Jack Guzman from Maine

Derek, what you see as a bevel in the picture is actually the polish on the inside. The adze is beveled on the outside.

As to the shape, I'm not sure but it just feels right in my hand. I like the knob on the bottom somewhat large because my grip isn't all that strong with arthritis. I use an inverted table similar to Curtis Buchanan's and it is a breeze to rough out a pine seat this way with this tool.