Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

drawer stop

Posts

drawer stop

#1

Jack Guzman from Maine

drawer stop

Jack Guzman from Maine

I built my wife an island for her kitchen. Butcher block top. She wanted a drawer she could access from either side so I built a shallow drawer with two fronts. A simple store bought knob type pull on each front. The drawer runs on a wood cleat on each side. I couldn't think of a way to have the drawer stop in the closed position so I never did anything about that. It drives me nuts though. That drawer is never closed right. It either sticks out on one side or the other. Is there a way to make the drawer naturally rest in the closed position? It's been about three years now and I need to do something about this for my sanity.---Jack

Re: drawer stop

#2

Re: drawer stop

Bob Entwisle in NJ

Hello Jack,

We were discussing your dilemma on the hand tool chat a few minutes ago and the idea we liked the best is:

"Have you considered a couple of rare earth magnets, one in the side of the drawer, one in the cabinet?"

Let us know what you come up with.

Best regards

Tuesday night Hand Tool chat crew:

Bob in NJ, William, Stuart and Mark

Re: drawer stop

#3

Re: drawer stop

Sgian Dubh

You should be able to use a ball catch on the bottom edge of each drawer front (or possibly the top edge if you don't mind seeing the catch). Each ball engages with the keep fitted to the lower horizontal divider (or upper divider/ underside of top). This assumes the drawer is of the inset type as opposed to the overlay pattern. Slainte.

Re: drawer stop

#4

Re: drawer stop

William Duffield

Overlay? I think you missed something important in Jack's description. The drawers go all the way through the cabinet and can be extended on either side of the cabinet. Only full inset drawer fronts need apply. :)

Re: drawer stop

#5

Re: drawer stop

Sgian Dubh

Ha, ha. You're right William. Brain fart. My mind had moved on to thinking about something else that I rather urgently needed to do as I was typing. Sorry about that, so, yes, it's got to be inset and can't be overlay.

Notice to self: concentrate on the job in hand. Slainte.

Re: drawer stop

#6

Re: drawer stop

Warren in Lancaster, PA

I think you could have a little wheel embedded in each drawer runner so that it protrudes 1/8 or a little less and a corresponding notch in the bottom of each drawer side. Then the drawer could come out by climbing over the wheel a bit, but would have a natural stopping place when it is closed.

Re: drawer stop

#7

Krenov catch (modified)

Wiley Horne--So. Calif.

Same idea as a bullet catch. But softer action, and you can make it yourself. Here’s a picture posted by Bill Tindall some years ago:

http://www.woodcentral.com/woodworking/forum/archives_handtools.pl/bid/3109/md/read/id/140378/sbj/the-krenov-catch/

Look at the one on the right. There is a ballpoint pen spring under the protrusion. The screw holding the catch in place is kept a little loose. There is a matching indent. Generally the catch will be in the case, and the indent in the moving part (door or drawer).

Wiley

Re: drawer stop

#8

Jack Guzman from Maine

good ideas

Jack Guzman from Maine

Thanks , I got some good ideas. I'm leaning toward a bullet catch.---Jack

Re: drawer stop

#9

Re: drawer stop

Patrick Chase

This was my first inclination as well: Some sort of cam/follower arrangement with a detent in the middle. As Warren says the drawer side can be the cam, a spring-loaded wheel the follower, and a notch in the middle the detent. There are many other variations using other surfaces as the "cam".