Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veneer question

Posts

Veneer question

#1

Paul Kramer

Veneer question

Paul Kramer

I am planning to veneer a solid maple box approximately 6" maximum H/W/L. The questions are: do I need to apply veneer to both the inside and the outside? For something this small what's the best method for attaching the veneer?

Thanks for any help in advance

Paul

Re: Veneer question

#2

Re: Veneer question

Tony - Memphis

I have broken the "veneer both sides" rule many may times. Never had an issue. I've done panels, small items, etc. I do usually finish both sides. Especially for small boxes, I sometimes like the contrast of a lighter veneer inside (although I usually use MDF and a veneer like satinwood on the inside).

For something that small, I would use whatever glue I had and a platen and clamps to clamp it. I've used the urea glues, liquid hide glue, and yellow glues. I tried the "new" glue from Joe's and have had pretty good luck with it. It is nice that it is water based and is not supposed to creep. I tried it on a round table top with lots of pieces and I have not seen any issues with it yet (a couple of years).

Tony

Re: Veneer question

#3

Paul Kramer

Re: Veneer question

Paul Kramer

Tony,

Thanks for your response. I am not familiar with the glue you mentioned from Joe's. Please elucidate.

Paul

Re: Veneer question

#5

Re: Veneer question

Wiley Horne--So. Calif.

Hi Paul,

Is it sawn veneer or the sliced (1/32 to 1/40 or so)? Reason for asking: I have seen sawn veneer of 3/32 or 1/8, and the associated wetting while gluing, do some things I didn't think it would do.

I'm no expert. In fact, the opposite. But if it is sawn veneer, I suggest at least keep both sides of the wood at the same wetness during gluing--use a wet towel on the off side during glue-up if using water-based glue.

Wiley

Re: Veneer question

#6

Paul Kramer

Thanks Tom and Wiley