Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A couple M&T questions

Posts

A couple M&T questions

#1

A couple M&T questions

Joe in a Cleveland suburb

I am making a step stool. 2 steps. Kinda Shaker looking.

I am making this similar to Christian Becksvoort's stool in #231–Jan/Feb 2013 FWW.

Each step has two mortises and the legs have matching tenons. I want to put a wedge in each tenon. Should the mortise have slight angles to accommodate the wedge? Any suggestions/tips for doing this?

Another question... why, when I chop a mortise by hand, do the walls seem to crumble and chunk out. Shown in the attached picture which is the bottom of one of the steps. They don't have smooth walls. It doesn't surprise me when using big box pine, but this is 3/4 Cherry. In this case I am using a 3/4" bench chisel, not a mortising chisel - don't have one that big. The chisel is, to me anyway, very sharp.

It's probably due to chopping across the grain I suppose. Just currious as to what you guys say.

Thanks for any suggestions.


Re: A couple M&T questions

#2

Re: A couple M&T questions

Wiley Horne--So. Calif.

Hi Joe and all,

Just a couple of questions which you have likely thought about. I'm not familiar with the Becksvoort design. Are the leg pieces angled? Is there bracing between legs, or a shear back piece? I'm thinking of the inch or so of short-grain outside the leg tenons, and the stresses against it.

Bracing connecting the legs, or a back piece tying the legs together, would cure any such worries.

Wiley

Re: A couple M&T questions

#3

Re: A couple M&T questions

north of the border

The mortises are angled slightly (2 degrees or so) on the outside faces. Make sure you orient the wedge properly so it does not split the wood.

The waste collapsed because you were trying to chisel to the line by vertical or horizontal cuts. To prevent that, you should cut (chop or pare) to create a small hill in the middle first.

Unless the cavity is huge and deep, the strength of the joint should not be affected.

One last word, a single wedged joint looks easy to a lot of people (who have not tried it), but it is more difficult than many realize.

ps "It's probably due to chopping across the grain I suppose." Chopping along the grain is a risky operation that must be approached with care.

Re: A couple M&T questions

#4

Re: A couple M&T questions

Bill Houghton, Sebastopol, CA

Cherry is still a pretty soft wood. And "sharp" is a neverending pursuit of improvement. You might be better off using a paring approach.

Re: A couple M&T questions

#5

Crumbly walls

Bill Tindall, E.Tn.

Use a smaller chisel and thinner shavings/cuts.

Re: A couple M&T questions

#6

Re: A couple M&T questions

Mark P

I work with Cherry and have found that,for me, that tearing is caused by taking a cut too thick.