Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Some information on lamated blades

Posts

Some information on lamated blades

#1

Some information on lamated blades

Bill Tindall, E.Tn.

While at the GA meet we met a retired General Manager from Crucible Steel. Persons in his position get to satisfy their curiosity with some nice toys. He did a carbon analysis across a vintage laminated blade. What he found was carbon migrated from the high carbon layer into the soft layer during fabrication of the lamination, providing a gradient of hardness between the two kinds of steel. No doubt this carbon migration and hardness gradient leads to a more robust lamination.

Re: Some information on lamated blades

#2

Ellis Walentine

Might this...

Ellis Walentine

... have to do with the forging technique?

Re: Some information on lamated blades

#3

Re: Might this...

Bill Tindall, E.Tn.

Atoms diffuse when they get hot enough and the matrix gets less viscous. I would expect the carbon moved because forging required the metal to be hot and "soft".

Re: Some information on lamated blades

#4

Re: Some information on lamated blades

TomD

Robust is sorta vague though. In general speech I wouldn't disagree, but a weld is super strong, you could probably glue the steel together with epoxy, any weld is very strong, for the purpose more than adequate. Pulling carbon out of the cutting steel could be negative, though it certainly isn't in the particular case since most of the welded blades I have used, probably all of them, have been superior.

One of the things I would like to know more about is that the welded blade seems more amenable to water quenching. One of those things i once knew the reason for, or at least an explanation.