New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

stanley 113 compass plane blades

Posts

stanley 113 compass plane blades

#1

stanley 113 compass plane blades

Joel Kawahara

I am looking to replace the blade in a used Stanley model 113. I see that Kunz has a replacement blade - has anyone used that blade and would you be able to relay your experiences?

Secondly, are there any other blades which will work as replacements should the Kunz be unsuitable?

Re: stanley 113 compass plane blades

#2

Re: stanley 113 compass plane blades

John Sayles

Hock makes one:

http://www.hocktools.com/products/bp.html

Re: stanley 113 compass plane blades

#3

Re: stanley 113 compass plane blades

Joel Kawahara

Thanks very much. it did not come up on search.

Joel

Re: stanley 113 compass plane blades

#4

Re: stanley 113 compass plane blades

Neal in SC

I have that plane. Since it is likely to go a long time between uses, I sharpened up the Stanley blade and use it. I couldn't justify spending money on an aftermarket blade for it. The stock blade works very well.

The problem you are likely to run into is that the mouth (on mine, anyway) is pretty tight. I can try tomorrow when I get back out to the shop, but I think any aftermarket blade worth considering may be too thick to work without enlarging the mouth. Since the mouth is in a pretty small piece of iron in a complicated assembly, I'd hesitate to do any modification.

I don't have any experience with Kunz blades, but I do have their scraper plane clone, and it is very low quality. I've seen posts that indicate their entire line is pretty low quality. I'd recommend you look at other options if you decide you really need to replace the blade.

HTH Neal

Re: stanley 113 compass plane blades

#5

As I suspected

Neal in SC

At 1 3/4 inches wide, that's a #3 blade and I only have one aftermarket blade; a Lie Nielsen. The stock Stanley blade measures .076 thick, and the LN is .097. The LN blade wouldn't work; it completely closed up the mouth and pressed against the front of the opening. A second problem you might have if you do replace the blade with a thicker one is the blade adjustment yoke wasn't long enough to engage in the hole in the cap iron (chip breaker). Stanley planes vary on how long that yoke is, so yours might work, but replacing them is a PITA if it doesn't.

All that said, I would recommend that unless there's a compelling reason to replace the blade, I'd stick with the stock blade. They stopped making them before World War 2 and hadn't "value engineered" the good steel out of the blades yet, so you aren't likely to see much improvement with an aftermarket blade. If you do need to replace the blade, there are aftermarket blades of the same thickness, I just can't think of the name of the manufacturer just now.

Neal