New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

sharpening knickers

Posts

sharpening knickers

#1

sharpening knickers

Joseph Piotrowski

happy new year!

I now have several wooden hand planes that have knickers. i was wondering about how you handle sharpening these and what media/devices you all have used.

most look(bat ears) something like this: http://www.datamp.org/patents/displayPatent.php?id=8809

i appreciate a technique or tooling advice.

TIA,

Joe P

Re: sharpening knickers

#2

Re: sharpening knickers

Tony

Personally I prefer the knickers I handle soft and off. (Some one had to do it)

Are the knickers/spurs rounded on the inside face and flat on the outside?

Re: sharpening knickers

#3

Re: sharpening knickers

William Duffield

Yes, they're flat on the outside, which needs to remain coplanar to the machined face of the plane. Therefore, unlike the cutters on wheel marking gauges, you should NOT try to sharpen them by laying them flat on an abrasive and polishing the flat face. Usually they were delivered installed on the plane unsharpened, the theory being that there was less chance of destroying an unsharpened point before you were ready to use it. The user would sharpen and resharpen one point until it was worn out and then sharpen and start using the second point.

Re: sharpening knickers

#4

Re: sharpening knickers

Wiley Horne--So. Calif.

Hi Joe,

I'll tell you how I have done it. And you don't have to do much forever, once you've set it up once. The double-nicker kind is what I have on dado planes. But single nickers tend to follow the same logic, since in many cases the flat outside edge is already pretty closely registered to either the plane side or the outer edge of the iron, as the case may be.

Anyways......as Wm. says, sharpen the inside rounded profile, leaving the outside alone, other than a lick to remove burr. To do the inside, I have done it two ways. First way is to use a slip stone, and just have at it, being careful to leave a rounded bottom on each nicker, and to keep the nickers the same length. Second way is to work each nicker along the edge of a regular square stone (I use water stones, but oil would work the same way), using a rolling action, the tilt of the iron to match the bevel of the nicker will make the 'off' nicker stand off the stone, preventing fouling.

Again, the main thing is to maintain the nicker's profile and above all, keep them the same length below the plane sole.

Wiley