New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Wood moulding plane

Posts

Wood moulding plane

#1

Wood moulding plane

Ken Martin

At a recent swap meet I got three wood moulding planes. Two are for tongue and groove however the wood wedge was stuck and couldn't be removed. I have managed to remove one but the other is stuck tight. Any suggestions on removing it?

Ken Martin

Re: Wood moulding plane

#2

Re: Wood moulding plane

Bill Houghton, Sebastopol, CA

Not sure about this, but you might try wrapping them in plastic and putting them in the freezer for a day.

Re: Wood moulding plane

#3

Re: Wood moulding plane

Wiley Horne--So. Calif.

Try tapping the iron from the top (the shank end) such that it passes down through the mouth of the plane and out. Don't wail on it, just some firm taps to see if you can budge it. If you can tap the iron through the bottom, then that will make some up-and-down wiggle room for the wedge and you may be able to work it free.

Wiley

Re: Wood moulding plane

#4

Thanks

Ken Martin

Thanks to both Bill and Wiley. I tried Wiley's method, managed to drive the cutter out, then tapped the wedge and managed pull it out. Now to clean and sharpen the cutters.

Ken