New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Sliding Dovetails with the Stanley #79

Posts

Sliding Dovetails with the Stanley #79

#1

Sliding Dovetails with the Stanley #79

Derek Cohen (in Perth, Australia)

I have finally got around to creating a pictorial of the Stanley #79 conversion into a dovetail plane. This was originally posted when I was building the Lingerie Chest.

The article is here: http://www.inthewoodshop.com/ShopMadeTools/SlidingDovetailsWithTheStanley79.html


Regards from Perth

Derek

Re: Sliding Dovetails with the Stanley #79

#2

Easier way to make female socket

Bill Tindall, E.Tn.

I learned this way in the Headley shop and have used it on numerous chests of drawers.


Mark out the location. Saw square shoulder and approximate bevel to about the depth required. Chisel out this waste. Refine depth with router plane.



Pare bevel with chisel and guide block. I can make one of these joints in a couple of minutes once set up. The chiseling motion is an arcingparing cut that progresses across the socket. It takes seconds to complete.

Re: Sliding Dovetails with the Stanley #79

#3

Re: Easier way to make female socket

Derek Cohen (in Perth, Australia)

Hi Bill

There are so many ways to create a male or female sliding dovetail. I have documented a number of these over the years - saw and chisel, router plane, dovetail planes, guides and freehand, stopped and through sockets. This is just one more method for the repertoire.

Regards from Perth

Derek