New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

making a table

Posts

making a table

#1

making a table

Bill Tindall, E.Tn.

Some years ago I bought a piece of Moroccan marble with fossils in it. Finally, I am getting around to making a table from it. The table will live in the dining room by a window and have plants on it some of the time. I intend to make 4 legs and a skirt and simply set the table on this arrangement.

I just was not in the mood to set up the hollow chisel mortise so I chopped them out by hand.


I don't do hand mortises often so a crutch is useful to me. The crutch in this case is a pilot hole at each end of the mortise, drilled slightly under the mortise size. It provides both a depth gauge and chip clearance for starting the mortise.


I start at the near end a proceed away from me with the bevel away from me. Whack and pry. I ginned up some patience and found things went better by taking small, about 1/16 inch, cuts.

The first one proceeded awkwardly, but as usual by the time I was done I was getting proficient. The blue crayon mark was made to ensure the mortise was marked out on the correct face of the leg.

Re: making a table

#2

Re: making a table

AZ in Colorado Springs

I usually use blue tape to mark the legs -- left, right, inside, up, down, etc. With a lengthy strip of tape and a sharpie marker I can be descriptive. Helpful especially if I get sidetracked for a few weeks

Re: making a table

#3

that is a good idea....

Bill Tindall, E.Tn.

...in the category of "why didn't I think of that". It is so easy to screw up parts that are right and left handed (that is, not interchangeable) or parts that have a preferred show face. I wind up with marks all over things like mortised legs. In the case at hand I planed off some critical markings before I got it assembled, resulting in confusion. Your tape idea would have been a better idea and I will use it in the future.