New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Anybody have the LV Small Plow Plane?

Posts

Anybody have the LV Small Plow Plane?

#1

Anybody have the LV Small Plow Plane?

Joe in a Cleveland suburb

Last winter I bought the subject plow plane. Then I sent it in to LV for the upgrade and also bought a 3/16" beading blade. I received it back last Spring from LV in the box and never opened until yesterday - no ww'ing time since last Spring.

BTW, this is the left handed version of the plane.

I am trying to figure out how I can use the beading blade on the edge of the board without leaving an edge like is shown in the below picture; my finger nail is on the edge. Shouldn't I be able to do this? Did I put it back together wrong?


Here you can see the blade is up against the body of the plane, it can't move over anymore. The piece of wood you see between the blade and the planes fence is an auxiliary fence I added.


Another shot of the blade installed.


If I move the blade to the other side of the board, I can get it to the edge, but then the depth stop has nothing to ride on.


I know the blade is probably sharper than I am, and I can't figure this out...

Thanks for any suggestions before I call LV for assistance. Hoping someone here has one of these little planes and knows what I am doing wrong.

Re: Anybody have the LV Small Plow Plane?

#2

Re: Anybody have the LV Small Plow Plane?

david weaver

Mortise a slot out of your fence for the blade and lever cap and all of that stuff to fit into. Bevel the back of the slot if it catches on things.

(cut it out as if you're making a plane - just saw to each side and pare or knock the waste right out cross-grain.)

Re: Anybody have the LV Small Plow Plane?

#3

Oh! Doh...

Joe in a Cleveland suburb

It took me a while. I read and re-read your response. A few times. Then it hit me.

You are saying to bury the the part of the cutter into the fence that is creating the edge/lip/fillet?... Right?!

I'll have to take a look tonight. Thanks for the help David (again).

Re: Anybody have the LV Small Plow Plane?

#4

Re: Oh! Doh...

david weaver

That's correct, take a chunk out of the fence and make it do your bidding :)

Re: Anybody have the LV Small Plow Plane?

#5

Re: Oh! Doh...

John S

In the iron fence, you will see a cut out where the blade would hit it. You should duplicate that cut out in your wooden fence, either the same depth or a little deeper.

I already have the cut out on my wooden fence because I use it for rabbets, That cut out lets me do inbetween sizes of rabbets, by burying part of a slightly larger blade.

Re: Anybody have the LV Small Plow Plane?

#6

That did it. Thanks!


Re: Anybody have the LV Small Plow Plane?

#7

Pictures

Derek Cohen (in Perth, Australia)

Here is the cut out in my Small Plow fence ...


This is a photo when I was experimenting with Stanley beading blades some years ago. It shows the relationship of the blade to the cut out ..


Hope this helps.

Regards from Perth

Derek

Re: Anybody have the LV Small Plow Plane?

#8

Thanks John.


Re: Anybody have the LV Small Plow Plane?

#9

Re: Pictures

Joe in a Cleveland suburb

Thanks Derek.

That is essentially what I did, although I need to work on it some more and make it so the shavings don't jam up so easily.

Thanks!